Beyerdynamic DT 700 Pro X vs Sennheiser HD 620S

Last updated: October 11, 2026

Short answer: the Beyerdynamic DT 700 Pro X. It ranks #98 of 216 over-ear headphones by sound quality, rated 3.8/5, at $279.99. The Sennheiser HD 620S ranks #112, rated 3.7/5, at $259.19, $20.80 cheaper, a saving that is not big enough to make up the sound-quality gap.

Beyerdynamic DT 700 Pro X vs Sennheiser HD 620S

What the Beyerdynamic DT 700 Pro X does well: Bass from 60 to 200 Hz lands right on the Harman target, and the 48 ohm, 100 dB sensitivity design drives easily from a laptop or interface. The catch: A deep 12.8 dB dip near 3.9 kHz pulls vocal presence and consonant clarity backward, and presence overall runs about 3.5 dB under target.

Why pick the Sennheiser HD 620S: Bass from 60 to 200 Hz is lifted about 2.6 dB while sub-bass sits within half a dB of target, giving a punchy, well extended low end. The tradeoff: At 150 ohms and 110 dB SPL/V it is more demanding than most headphones here and benefits from a headphone amp rather than a phone.

Buy the Beyerdynamic DT 700 Pro X. It is rated higher for sound quality, and the $20.80 you would save on the Sennheiser HD 620S does not close the gap.

Still deciding? The full Headphones rankings cover every ranked option.

Specifications Side By Side

Beyerdynamic DT 700 Pro X Sennheiser HD 620S
Price$279.99$259.19
Ranked#98 of 216 in Over-Ear Headphones#112 of 216 in Over-Ear Headphones
Form FactorOver-earOver-ear
Harman Preference Score77 (measured by oratory1990, via AutoEQ)74 (measured by oratory1990, via AutoEQ)
Deviation From Target2.58 dB standard deviation2.19 dB standard deviation
Tonal Tilt-0.34 (negative is warmer, positive brighter)-0.80 (negative is warmer, positive brighter)
Sub-bass ExtensionWithin 6 dB of target down to 20 Hz (-0.5 dB at 30 Hz)Within 6 dB of target down to 20 Hz (-1.3 dB at 30 Hz)
ConnectionWiredWired
BackClosedClosed
Driver TypeDynamicDynamic
Impedance48 ohms150 ohms
Sensitivity100 dB SPL (1mW/500Hz)110 dB SPL/V
Weight0.8 lbs (350 g)-
Frequency Response5Hz - 40kHz (Manufacturer specified)6Hz - 30kHz (Manufacturer specified)
Drivers-1 x 42mm dynamic

More worthwhile head-to-heads for Beyerdynamic DT 700 Pro X:

Prices on this page were last checked October 11, 2026 at 4:59 PM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.

As an eBay Partner, we may be compensated if you make a purchase.

The Two Headphones In Full

Beyerdynamic DT 700 Pro X: $279.99 Amazon eBay

Beyerdynamic DT 700 Pro X ranking card

Pros: Bass from 60 to 200 Hz lands right on the Harman target, and the 48 ohm, 100 dB sensitivity design drives easily from a laptop or interface. The closed back and 350 g weight suit tracking and long monitoring sessions where bleed matters. A preference score of 77 with a fairly smooth 2.6 dB deviation makes it an easy listen overall.

Cons: A deep 12.8 dB dip near 3.9 kHz pulls vocal presence and consonant clarity backward, and presence overall runs about 3.5 dB under target. Sub-bass is about 2 dB light, so the lowest notes lack rumble. The Austrian Audio Hi-X65 matches its rating for noticeably less money, so the price is hard to justify on sound alone.

ReleasedOct 2021 (5 years ago)
BackClosed
ConnectionWired
Deviation From Target2.58 dB standard deviation
Driver TypeDynamic
Form FactorOver-ear
Frequency Response5Hz - 40kHz (Manufacturer specified)
Harman Preference Score77 (measured by oratory1990, via AutoEQ)
Impedance48 ohms
Sensitivity100 dB SPL (1mW/500Hz)
Sub-bass ExtensionWithin 6 dB of target down to 20 Hz (-0.5 dB at 30 Hz)
Tonal Tilt-0.34 (negative is warmer, positive brighter)
Weight0.8 lbs (350 g)
EQ preset to match the Harman target

Set a preamp of -4.6 dB, then add these filters in any parametric equalizer (Wavelet, Equalizer APO, Peace, or a player with parametric EQ). Calculated by AutoEQ from its measured frequency response.

FilterFrequencyGainQ
Low shelf105 Hz+1.0 dB0.70
Peak131 Hz-4.1 dB1.24
Peak2,692 Hz-2.6 dB0.37
Peak265 Hz+4.2 dB1.71
Peak3,557 Hz+6.8 dB2.70
High shelf10,000 Hz-0.2 dB0.70
Peak5,709 Hz-2.0 dB3.38
Peak62 Hz+1.5 dB3.47
Peak88 Hz-0.8 dB3.25
Peak4,028 Hz+1.4 dB5.91

Sennheiser HD 620S: $259.19 Amazon eBay

Sennheiser HD 620S ranking card

Pros: Bass from 60 to 200 Hz is lifted about 2.6 dB while sub-bass sits within half a dB of target, giving a punchy, well extended low end. The upper mids and presence stay close to the target, so vocals sound natural and clear. The closed back isolates well for private listening.

Cons: At 150 ohms and 110 dB SPL/V it is more demanding than most headphones here and benefits from a headphone amp rather than a phone. Treble from 6 to 10 kHz is about 2.6 dB low with a 6.9 dB dip near 9.5 kHz, which softens cymbals and sibilance. The Audio-Technica ATH-M50x holds a higher rating for a much lower price. See headphone amps and DACs with enough power to drive it.

BackClosed
ConnectionWired
Deviation From Target2.19 dB standard deviation
Driver TypeDynamic
Drivers1 x 42mm dynamic
Form FactorOver-ear
Frequency Response6Hz - 30kHz (Manufacturer specified)
Harman Preference Score74 (measured by oratory1990, via AutoEQ)
Impedance150 ohms
Sensitivity110 dB SPL/V
Sub-bass ExtensionWithin 6 dB of target down to 20 Hz (-1.3 dB at 30 Hz)
Tonal Tilt-0.80 (negative is warmer, positive brighter)
EQ preset to match the Harman target

Set a preamp of -1.8 dB, then add these filters in any parametric equalizer (Wavelet, Equalizer APO, Peace, or a player with parametric EQ). Calculated by AutoEQ from its measured frequency response.

FilterFrequencyGainQ
Low shelf105 Hz+0.4 dB0.70
Peak112 Hz-5.7 dB1.93
Peak8,995 Hz+3.2 dB1.57
Peak49 Hz+0.9 dB1.25
Peak1,644 Hz+2.0 dB3.09
High shelf10,000 Hz-4.3 dB0.70
Peak615 Hz-1.9 dB1.75
Peak234 Hz+2.0 dB3.58
Peak2,761 Hz-2.7 dB6.00
Peak843 Hz+1.6 dB4.59