Short answer: the Wharfedale Linton 85 for better sound quality, the Dynaudio Emit 20 for the lower price. The Wharfedale Linton 85 ranks #32 of 122 bookshelf speakers at $1699.99. The Dynaudio Emit 20 ranks #72 at $1049, $650.99 cheaper.
What the Wharfedale Linton 85 offers: Very neutral frequency response and good bass extension. Watch for: The spacing of the drivers makes the vertical off axis not very good
What the Dynaudio Emit 20 offers: Two-way design with a 28mm Esotar soft dome tweeter (Hexis-damped) and an 18cm mid-woofer, using a first-order crossover on the tweeter and second-order on the woofer. Exceptional bass extension for a bookshelf speaker - reaches a clean, authoritative 40Hz in-room, rare enough that the reviewer says most listeners could skip a subwoofer for typical music. Very low distortion across the board, staying below 1% THD down to 40Hz at 86dB and below 3% even at 96dB - unusually clean bass performance where most two-way bookshelf speakers start rising in distortion around 80Hz. Wide, remarkably consistent horizontal directivity (about ±50-60°) that holds steady up to roughly 13kHz - rare for a speaker in this format, thanks to a beveled tweeter edge that acts as a mild waveguide. Excellent compression and dynamic-range linearity at the frequency extremes, actually showing slight bass enhancement rather than the sharp low-end compression common in similarly-sized bookshelf speakers. Watch for: A resonance around 600-800Hz gives snares and similar percussion a muffled, flat quality lacking impact - confirmed as originating in the woofer itself (isolated via measurements of the raw driver out of the cabinet), and attempts at constrained-layer damping didn’t resolve it. A peak around 4kHz adds a sharp, edgy quality to some male vocals. A roughly 5dB boost above 10kHz gives cymbals and hi-hats excess shimmer that can sound unnatural, especially pointed directly on-axis. Vertical dispersion shows two separate crossover-related notches (above and below the tweeter reference line around 5kHz) rather than the usual single one, a direct consequence of the shallow crossover slopes used on both drivers. Multitone distortion is elevated in the midrange, possibly due to the woofer’s magnet structure lacking a shorting ring. Best aimed slightly off-axis (about 10-15° of toe-out) to tame the excess high-frequency shimmer, rather than pointed straight at the listener.
Buy the Wharfedale Linton 85 if sound quality matters more than the price. Buy the Dynaudio Emit 20 if the price matters more than sound quality.
Specifications Side By Side
| Wharfedale Linton 85 | Dynaudio Emit 20 | |
|---|---|---|
| Price | $1699.99 | $1,049.00 |
| Ranked | #32 of 122 in Large Size Bookshelf Speakers | #72 of 122 in Large Size Bookshelf Speakers |
| Bass Extension (-10dB) | 35Hz (measured, Erin’s Audio Corner) | 33Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 52Hz (measured, Erin’s Audio Corner) | 54Hz (measured, Erin’s Audio Corner) |
| Dimensions | 22.2"H x 11.8"W x 13"D (563.9 x 299.7 x 330.2 mm) | 14.6"H x 8.1"W x 12.3"D (370.0 x 205.0 x 312.0 mm) |
| Impedance | 6 ohms nominal, 3.5 ohms minimum (measured above 80Hz, Erin’s Audio Corner) | 6 ohms nominal (5.5 ohms minimum above 80Hz, measured, Erin’s Audio Corner) |
| Drivers | 8"(200mm) black woven Kevlar® cone woofer, 5"(135mm) black woven Kevlar® cone midrange, 1" (25mm) soft dome tweeter | 7.1" Magnesium Silicate Polymer woofer, 1.1" Cerotar soft dome with Hexis tweeter |
| Sensitivity | 85.1dB (measured average 300Hz-3kHz @ 2.83V/1m, Erin’s Audio Corner) | 83.5dB (measured, Erin’s Audio Corner; 86dB manufacturer specified) |
| Weight | 40.6 lbs / 18.4 kg each | 12.8 lbs / 5.8 kg |
| Woofer Cabinet | ported, rear | ported, rear |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Revel Concerta2 M16 vs Philharmonic BMR Monitor
- MoFi SourcePoint 8 vs Klipsch RP-600M II
- KEF R3 Meta vs Klipsch RP-600M II
- Technics SB-C700 vs Dynaudio Emit 20
- Wharfedale Linton 85 vs AsciLab C6B
Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Wharfedale Linton 85: $1699.99 Crutchfield eBay
Pros: Very neutral frequency response and good bass extension.
Cons: The spacing of the drivers makes the vertical off axis not very good
Full Wharfedale Linton 85 review and specifications →
| Bass Extension (-10dB) | 35Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 52Hz (measured, Erin's Audio Corner) |
| Dimensions | 22.2"H x 11.8"W x 13"D (563.9 x 299.7 x 330.2 mm) |
| Drivers | 8"(200mm) black woven Kevlar® cone woofer, 5"(135mm) black woven Kevlar® cone midrange, 1" (25mm) soft dome tweeter |
| Impedance | 6 ohms nominal, 3.5 ohms minimum (measured above 80Hz, Erin's Audio Corner) |
| Sensitivity | 85.1dB (measured average 300Hz-3kHz @ 2.83V/1m, Erin's Audio Corner) |
| Weight | 40.6 lbs / 18.4 kg each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Erin’s Audio Corner: Discover Why I Can’t Stop Raving About the Wharfedale Linton 85th Anniversary Speaker More from Erin’s Audio Corner →
- Erin’s Audio Corner Website Wharfedale Linton 85 Review
- Erin’s Audio Corner: My Top 5 Speakers at Any Price
- Erin’s Audio Corner: Upgrade Your Sound with These 6 Surprisingly Affordable Speakers!
- Erin’s Audio Corner: My Personal Favorite Speakers Under $2500
- Erin’s Audio Corner Measurements (spinorama.org)
- Reddit Search for Wharfedale Linton 85 Review
- Head-to-Head Comparisons
- Wharfedale Linton 85 vs Revel M126Be
- Wharfedale Linton 85 vs ELAC VELA BS 403
- Wharfedale Linton 85 vs Dynaudio Heritage Special
- Wharfedale Linton 85 vs GR-Research NX-Bravo
- Wharfedale Linton 85 vs Wharfedale Super Linton
- Wharfedale Linton 85 vs Emotiva Airmotiv XB2
- Wharfedale Linton 85 vs ELAC Debut 3.0 DB63
- Wharfedale Linton 85 vs JBL HDI-1600
- See all 27 comparisons
Dynaudio Emit 20: $1,049.00 Amazon eBay
Pros: Two-way design with a 28mm Esotar soft dome tweeter (Hexis-damped) and an 18cm mid-woofer, using a first-order crossover on the tweeter and second-order on the woofer. Exceptional bass extension for a bookshelf speaker - reaches a clean, authoritative 40Hz in-room, rare enough that the reviewer says most listeners could skip a subwoofer for typical music. Very low distortion across the board, staying below 1% THD down to 40Hz at 86dB and below 3% even at 96dB - unusually clean bass performance where most two-way bookshelf speakers start rising in distortion around 80Hz. Wide, remarkably consistent horizontal directivity (about ±50-60°) that holds steady up to roughly 13kHz - rare for a speaker in this format, thanks to a beveled tweeter edge that acts as a mild waveguide. Excellent compression and dynamic-range linearity at the frequency extremes, actually showing slight bass enhancement rather than the sharp low-end compression common in similarly-sized bookshelf speakers.
Cons: A resonance around 600-800Hz gives snares and similar percussion a muffled, flat quality lacking impact - confirmed as originating in the woofer itself (isolated via measurements of the raw driver out of the cabinet), and attempts at constrained-layer damping didn’t resolve it. A peak around 4kHz adds a sharp, edgy quality to some male vocals. A roughly 5dB boost above 10kHz gives cymbals and hi-hats excess shimmer that can sound unnatural, especially pointed directly on-axis. Vertical dispersion shows two separate crossover-related notches (above and below the tweeter reference line around 5kHz) rather than the usual single one, a direct consequence of the shallow crossover slopes used on both drivers. Multitone distortion is elevated in the midrange, possibly due to the woofer’s magnet structure lacking a shorting ring. Best aimed slightly off-axis (about 10-15° of toe-out) to tame the excess high-frequency shimmer, rather than pointed straight at the listener.
Full Dynaudio Emit 20 review and specifications →
| Bass Extension (-10dB) | 33Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 54Hz (measured, Erin's Audio Corner) |
| Dimensions | 14.6"H x 8.1"W x 12.3"D (370.0 x 205.0 x 312.0 mm) |
| Drivers | 7.1" Magnesium Silicate Polymer woofer, 1.1" Cerotar soft dome with Hexis tweeter |
| Impedance | 6 ohms nominal (5.5 ohms minimum above 80Hz, measured, Erin's Audio Corner) |
| Sensitivity | 83.5dB (measured, Erin's Audio Corner; 86dB manufacturer specified) |
| Weight | 12.8 lbs / 5.8 kg |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Dynaudio Emit 20 vs Klipsch RP-600M II
- Dynaudio Emit 20 vs JBL Studio 630
- Dynaudio Emit 20 vs Behringer B2030P
- Dynaudio Emit 20 vs Infinity Reference R162
- Dynaudio Emit 20 vs Infinity IL10
- Dynaudio Emit 20 vs SVS Ultra Bookshelf
- Dynaudio Emit 20 vs Dynaudio Special Forty
- Dynaudio Emit 20 vs ELAC Debut 2.0 B6.2
- See all 26 comparisons