Short answer: the Dynaudio Emit 20 for better sound quality, the Triangle Borea BR03 for the lower price. The Dynaudio Emit 20 ranks #75 of 130 bookshelf speakers at $1049. The Triangle Borea BR03 ranks #109 at $399, $650 cheaper.
What the Triangle Borea BR03 offers: Bass output is genuinely decent for the price - measured extension reaches F3 57Hz/F10 42Hz, which the reviewer had no real complaints about. Dual front-firing ports and a well-stuffed, well-braced cabinet. Solid build quality overall. Watch for: A noticeable mid-range suckout, most pronounced in the upper mid-range/lower treble, that the reviewer attributes to cabinet resonances and driver breakup rather than a deliberate voicing choice - it makes vocals and instruments sound recessed and thin rather than warm. Sibilance in the 4-8kHz region shows up on every track the reviewer tried. Measured minimum impedance dips to about 4.2 ohms (with an even lower EPDR), despite the speaker and its own rear panel being labeled 8 ohms - worth knowing if you’re planning to drive these with a receiver/AVR that assumes an 8-ohm nominal load. The reviewer is upfront that this speaker has a devoted following among other reviewers, but says he specifically doesn’t hear what they hear and wants people who own it to trust their own ears rather than assume something’s wrong with their hearing if they don’t love it either.
What the Dynaudio Emit 20 offers: Two-way design with a 28mm Esotar soft dome tweeter (Hexis-damped) and an 18cm mid-woofer, using a first-order crossover on the tweeter and second-order on the woofer. Exceptional bass extension for a bookshelf speaker - reaches a clean, authoritative 40Hz in-room, rare enough that the reviewer says most listeners could skip a subwoofer for typical music. Very low distortion across the board, staying below 1% THD down to 40Hz at 86dB and below 3% even at 96dB - unusually clean bass performance where most two-way bookshelf speakers start rising in distortion around 80Hz. Wide, remarkably consistent horizontal directivity (about ±50-60°) that holds steady up to roughly 13kHz - rare for a speaker in this format, thanks to a beveled tweeter edge that acts as a mild waveguide. Excellent compression and dynamic-range linearity at the frequency extremes, actually showing slight bass enhancement rather than the sharp low-end compression common in similarly-sized bookshelf speakers. Watch for: A resonance around 600-800Hz gives snares and similar percussion a muffled, flat quality lacking impact - confirmed as originating in the woofer itself (isolated via measurements of the raw driver out of the cabinet), and attempts at constrained-layer damping didn’t resolve it. A peak around 4kHz adds a sharp, edgy quality to some male vocals. A roughly 5dB boost above 10kHz gives cymbals and hi-hats excess shimmer that can sound unnatural, especially pointed directly on-axis. Vertical dispersion shows two separate crossover-related notches (above and below the tweeter reference line around 5kHz) rather than the usual single one, a direct consequence of the shallow crossover slopes used on both drivers. Multitone distortion is elevated in the midrange, possibly due to the woofer’s magnet structure lacking a shorting ring. Best aimed slightly off-axis (about 10-15° of toe-out) to tame the excess high-frequency shimmer, rather than pointed straight at the listener.
Buy the Triangle Borea BR03 if the price matters more than sound quality. Buy the Dynaudio Emit 20 if sound quality matters more than the price.
Skip the Triangle Borea BR03 if sound quality matters to you. It ranks near the bottom of the 130 bookshelf speakers.
Looking for alternatives? See the complete Passive Home rankings.
Specifications Side By Side
| Triangle Borea BR03 | Dynaudio Emit 20 | |
|---|---|---|
| Price | $399.00 per pair | $1,049.00 per pair |
| Ranked | #109 of 130 in Large Size Bookshelf Speakers | #75 of 130 in Large Size Bookshelf Speakers |
| Drivers | 6.5" natural cellulose midwoofer, 1" (25mm) EFS silk dome tweeter | 7.1" Magnesium Silicate Polymer woofer, 1.1" Cerotar soft dome with Hexis tweeter |
| Crossover Frequency | 3600Hz | - |
| Dimensions | 14.96"H x 8.11"W x 12.36"D | 14.6"H x 8.1"W x 12.3"D (370.0 x 205.0 x 312.0 mm) |
| Weight | 13.2 lbs (6 kg) each | 12.8 lbs (5.8 kg) |
| Impedance | 8 ohms nominal (manufacturer spec), 4.2 ohms minimum (measured, Erin's Audio Corner) | 6 ohms nominal (5.5 ohms minimum above 80Hz, measured, Erin's Audio Corner) |
| Sensitivity | 87.5dB (measured at 2.83V/1m, Erin's Audio Corner) | 83.5dB (measured, Erin's Audio Corner; 86dB manufacturer specified) |
| Bass Extension (-3dB) | 57Hz (measured, Erin's Audio Corner) | 54Hz (measured, Erin's Audio Corner) |
| Bass Extension (-10dB) | 42Hz (measured, Erin's Audio Corner) | 33Hz (measured, Erin's Audio Corner) |
| Recommended Power | 100W | - |
| Woofer Cabinet | ported, dual front ports | ported, rear |
| Spinorama Preference Score | 3.12 | 3.35 |
| Spinorama Preference Score with Perfect Sub | 5.47 | 5.05 |
Related Speaker Comparisons
How Dynaudio Emit 20 compares with other leading options:
- Dynaudio Emit 20 vs Perlisten S4b
- KEF Reference 1 Meta vs Dynaudio Emit 20
- Dynaudio Emit 20 vs GR-Research NX-Studio
- Dynaudio Emit 20 vs AsciLab C6B
- Audio First Cadentia 3 vs Dynaudio Emit 20
Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Triangle Borea BR03: $399.00 per pair Amazon eBay
Pros: Bass output is genuinely decent for the price - measured extension reaches F3 57Hz/F10 42Hz, which the reviewer had no real complaints about. Dual front-firing ports and a well-stuffed, well-braced cabinet. Solid build quality overall. Measured bass extension of 57Hz (-3dB), with a measured sensitivity of 87.5dB.
Cons: A noticeable mid-range suckout, most pronounced in the upper mid-range/lower treble, that the reviewer attributes to cabinet resonances and driver breakup rather than a deliberate voicing choice - it makes vocals and instruments sound recessed and thin rather than warm. Sibilance in the 4-8kHz region shows up on every track the reviewer tried. Measured minimum impedance dips to about 4.2 ohms (with an even lower EPDR), despite the speaker and its own rear panel being labeled 8 ohms - worth knowing if you’re planning to drive these with a receiver/AVR that assumes an 8-ohm nominal load. The reviewer is upfront that this speaker has a devoted following among other reviewers, but says he specifically doesn’t hear what they hear and wants people who own it to trust their own ears rather than assume something’s wrong with their hearing if they don’t love it either.
Full Triangle Borea BR03 review and specifications →
| Bass Extension (-10dB) | 42Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 57Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 3600Hz |
| Dimensions | 14.96"H x 8.11"W x 12.36"D |
| Drivers | 6.5" natural cellulose midwoofer, 1" (25mm) EFS silk dome tweeter |
| Impedance | 8 ohms nominal (manufacturer spec), 4.2 ohms minimum (measured, Erin's Audio Corner) |
| Recommended Power | 100W |
| Sensitivity | 87.5dB (measured at 2.83V/1m, Erin's Audio Corner) |
| Spinorama Preference Score | 3.12 |
| Spinorama Preference Score with Perfect Sub | 5.47 |
| Weight | 13.2 lbs (6 kg) each |
| Woofer Cabinet | ported, dual front ports |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Triangle Borea BR03 vs B&W 805S
- Triangle Borea BR03 vs Wharfedale Diamond 9.1
- Triangle Borea BR03 vs Klipsch RP-600M
- Triangle Borea BR03 vs Sonus Faber Lumina II Amator
- Triangle Borea BR03 vs Aperion Audio Verus V8B
- Triangle Borea BR03 vs KEF Q350
- Triangle Borea BR03 vs Sonus Faber Sonetto II G2
- Triangle Borea BR03 vs Emotiva Airmotiv B2+
- See all 51 comparisons
Dynaudio Emit 20: $1,049.00 per pair Amazon eBay
Pros: Two-way design with a 28mm Esotar soft dome tweeter (Hexis-damped) and an 18cm mid-woofer, using a first-order crossover on the tweeter and second-order on the woofer. Exceptional bass extension for a bookshelf speaker - reaches a clean, authoritative 40Hz in-room, rare enough that the reviewer says most listeners could skip a subwoofer for typical music. Very low distortion across the board, staying below 1% THD down to 40Hz at 86dB and below 3% even at 96dB - unusually clean bass performance where most two-way bookshelf speakers start rising in distortion around 80Hz. Wide, remarkably consistent horizontal directivity (about ±50-60°) that holds steady up to roughly 13kHz - rare for a speaker in this format, thanks to a beveled tweeter edge that acts as a mild waveguide. Excellent compression and dynamic-range linearity at the frequency extremes, actually showing slight bass enhancement rather than the sharp low-end compression common in similarly-sized bookshelf speakers. Measured bass extension of 54Hz (-3dB), with a measured sensitivity of 83.5dB.
Cons: A resonance around 600-800Hz gives snares and similar percussion a muffled, flat quality lacking impact - confirmed as originating in the woofer itself (isolated via measurements of the raw driver out of the cabinet), and attempts at constrained-layer damping didn’t resolve it. A peak around 4kHz adds a sharp, edgy quality to some male vocals. A roughly 5dB boost above 10kHz gives cymbals and hi-hats excess shimmer that can sound unnatural, especially pointed directly on-axis. Vertical dispersion shows two separate crossover-related notches (above and below the tweeter reference line around 5kHz) rather than the usual single one, a direct consequence of the shallow crossover slopes used on both drivers. Multitone distortion is elevated in the midrange, possibly due to the woofer’s magnet structure lacking a shorting ring. Best aimed slightly off-axis (about 10-15° of toe-out) to tame the excess high-frequency shimmer, rather than pointed straight at the listener.
Full Dynaudio Emit 20 review and specifications →
| Bass Extension (-10dB) | 33Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 54Hz (measured, Erin's Audio Corner) |
| Dimensions | 14.6"H x 8.1"W x 12.3"D (370.0 x 205.0 x 312.0 mm) |
| Drivers | 7.1" Magnesium Silicate Polymer woofer, 1.1" Cerotar soft dome with Hexis tweeter |
| Impedance | 6 ohms nominal (5.5 ohms minimum above 80Hz, measured, Erin's Audio Corner) |
| Sensitivity | 83.5dB (measured, Erin's Audio Corner; 86dB manufacturer specified) |
| Spinorama Preference Score | 3.35 |
| Spinorama Preference Score with Perfect Sub | 5.05 |
| Weight | 12.8 lbs (5.8 kg) |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Dynaudio Emit 20 vs Klipsch RP-600M II
- Dynaudio Emit 20 vs Philharmonic BMR Monitor
- Dynaudio Emit 20 vs JBL Studio 630
- Dynaudio Emit 20 vs Behringer B2030P
- Dynaudio Emit 20 vs Mission LX-3 MKII
- Dynaudio Emit 20 vs Polk Signature Elite ES20
- Dynaudio Emit 20 vs GR-Research X-LS Encore
- Dynaudio Emit 20 vs Infinity IL10
- See all 63 comparisons