Short answer: the Dynaudio Contour 20i for better sound quality, the Sonus Faber Sonetto II G2 for the lower price. The Dynaudio Contour 20i ranks #60 of 130 bookshelf speakers at $5750. The Sonus Faber Sonetto II G2 ranks #103 at $3500, $2250 cheaper.
What the Sonus Faber Sonetto II G2 offers: Two-way design with a 1.125” damped Apex Dome silk tweeter and 6.5” cone woofer, using a base of concrete, aluminum, and steel with under-cabinet venting. Notably more neutral than Sonus Faber’s own Lumina 2, which runs 2-5dB hotter in the treble. Horizontal directivity narrows at a fairly constant, well-behaved rate rather than narrowing-then-widening-then-narrowing like some rivals (including the Lumina 2), meaning sidewall reflections match the direct sound well enough that the reviewer doesn’t recommend sidewall absorption for this speaker. The tweeter-to-woofer crossover handoff around 3kHz looks clean, suggesting a higher-order crossover than typical for the size/price class. Good dynamic range - the low end loses only about 2dB from 76dB to 96dB, otherwise holding up well. Not a difficult amplifier load (about 4.2 ohms minimum impedance). Bass extension reaches a genuine 50Hz in-room, fuller than the Lumina 2. Watch for: Sounds notably bright pointed directly on-axis; toeing the speaker out about 30° reduces treble energy and sibilance meaningfully. A resonance around 700Hz gives vocals a slightly nasal, hollow quality. A dip in the upper midrange (roughly 1-2kHz) reduces perceived detail and attack, while the elevated treble can read as “analytical” or “detailed” to some listeners despite being a coloration rather than true resolution. Needs more clearance from the rear wall than some rivals - about 1.5-2 feet in an ideal room, more or less depending on your specific room modes - or the 80-120Hz region can become boomy. Vertical listening window is limited to about ±10-15° from the tweeter axis. Some unexplained directivity irregularities appear around 1.2kHz and 1.6kHz, possibly port-related, along with a longer decay in the 800Hz-1600Hz range in burst-decay measurements. Multitone distortion approaches the reviewer’s 3% threshold through the midrange, though likely not obviously audible without direct A/B comparison. A resonance in the cabinet appears around 400Hz in impedance measurements.
What the Dynaudio Contour 20i offers: Two-way design with a 1.125” Esotar2i silk dome tweeter and a 7” magnesium silicate polymer woofer in a vented enclosure. A shallow bass rolloff profile lets it sit closer to a wall (about 1-2 feet worked best in testing) without becoming boomy, and makes subwoofer integration comparatively easy. Very wide horizontal radiation (about ±70° through the midrange) gives an enveloping, spacious sound in a suitably sized room. On-axis response holds within about ±3dB overall and ±1.5dB through the midrange. Attractive build quality with a distinctive metal front baffle and gloss finish options. Long-term compression stays good up to 96dB, and short-term compression is within about 0.5dB at that same level. Watch for: Notably room-dependent: sounds too bright in the lower treble in smaller rooms with close sidewalls, needing sidewall absorption to sound neutral, while performing better in larger or more open rooms without that treatment. A roughly 2dB lift in the lower treble combined with wide dispersion means more energy reflecting off sidewalls than some listeners will prefer. Relatively low sensitivity (about 82.5dB measured). Unusually sensitive to amplifier output impedance - high-output-impedance amps like tube or SET designs introduce up to a 2dB dip in the midrange, making the sound more mellow rather than “warmer,” the opposite of what many tube-amp buyers expect. Elevated harmonic and multitone distortion around 700Hz, which the reviewer attributes to typical cone-edge/surround behavior common across many driver brands, though it stands out on the measurement graphs. An upper-midrange dip around 2kHz can reduce attack and clarity on vocals and brass instruments. Vertical listening window is fairly narrow (roughly -20° to +30°) - moving outside that range causes a noticeable tonal shift, unlike coaxial designs that tolerate more vertical movement.
Buy the Sonus Faber Sonetto II G2 if the price is the priority over sound quality, or the Dynaudio Contour 20i if sound quality is the priority over the price.
Skip the Sonus Faber Sonetto II G2 if sound quality matters to you. It ranks near the bottom of the 130 bookshelf speakers.
Want more options? Browse the full Passive Home rankings.
Specifications Side By Side
| Sonus Faber Sonetto II G2 | Dynaudio Contour 20i | |
|---|---|---|
| Price | $3500 per pair | $5750 per pair |
| Ranked | #103 of 130 in Large Size Bookshelf Speakers | #60 of 130 in Large Size Bookshelf Speakers |
| Bass Extension (-10dB) | 38Hz (measured, Erin's Audio Corner) | 32Hz (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 62Hz (measured, Erin's Audio Corner) | 56Hz (measured, Erin's Audio Corner) |
| Impedance | 4 ohms nominal (4.2 ohms minimum, measured by Erin's Audio Corner) | 4 ohms |
| Sensitivity | 87dB (measured, Erin's Audio Corner) | 82.5dB |
| Drivers | 1x 6.5" mid-woofer (paper cone), 1x 1.1" (28mm) DAD soft dome tweeter | 18 cm MSP woofer, 28mm Esotar 2i with Hexis tweeter |
| Weight | 38.4 lbs (17.4 kg) | 30.9 lbs (14 kg) each |
| Dimensions | 16.3"H x 8.9"W x 14"D (414.3 x 227.0 x 355.6 mm) | 17.4"H x 8.5"W x 14.2"D (442 x 215.9 x 360.7 mm) |
| Woofer Cabinet | ported, front | ported, rear |
| Spinorama Preference Score | 3.34 | - |
| Spinorama Preference Score with Perfect Sub | 5.62 | - |
Related Speaker Comparisons
More top alternatives to Dynaudio Contour 20i:
- Perlisten S4b vs Dynaudio Contour 20i
- KEF Reference 1 Meta vs Dynaudio Contour 20i
- GR-Research NX-Studio vs Dynaudio Contour 20i
- AsciLab C6B vs Dynaudio Contour 20i
- Audio First Cadentia 3 vs Dynaudio Contour 20i
Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Sonus Faber Sonetto II G2: $3500 per pair Crutchfield eBay
Pros: Two-way design with a 1.125” damped Apex Dome silk tweeter and 6.5” cone woofer, using a base of concrete, aluminum, and steel with under-cabinet venting. Notably more neutral than Sonus Faber’s own Lumina 2, which runs 2-5dB hotter in the treble. Horizontal directivity narrows at a fairly constant, well-behaved rate rather than narrowing-then-widening-then-narrowing like some rivals (including the Lumina 2), meaning sidewall reflections match the direct sound well enough that the reviewer doesn’t recommend sidewall absorption for this speaker. The tweeter-to-woofer crossover handoff around 3kHz looks clean, suggesting a higher-order crossover than typical for the size/price class. Good dynamic range - the low end loses only about 2dB from 76dB to 96dB, otherwise holding up well. Not a difficult amplifier load (about 4.2 ohms minimum impedance). Bass extension reaches a genuine 50Hz in-room, fuller than the Lumina 2. Measured bass extension of 62Hz (-3dB), with a measured sensitivity of 87dB.
Cons: Sounds notably bright pointed directly on-axis; toeing the speaker out about 30° reduces treble energy and sibilance meaningfully. A resonance around 700Hz gives vocals a slightly nasal, hollow quality. A dip in the upper midrange (roughly 1-2kHz) reduces perceived detail and attack, while the elevated treble can read as “analytical” or “detailed” to some listeners despite being a coloration rather than true resolution. Needs more clearance from the rear wall than some rivals - about 1.5-2 feet in an ideal room, more or less depending on your specific room modes - or the 80-120Hz region can become boomy. Vertical listening window is limited to about ±10-15° from the tweeter axis. Some unexplained directivity irregularities appear around 1.2kHz and 1.6kHz, possibly port-related, along with a longer decay in the 800Hz-1600Hz range in burst-decay measurements. Multitone distortion approaches the reviewer’s 3% threshold through the midrange, though likely not obviously audible without direct A/B comparison. A resonance in the cabinet appears around 400Hz in impedance measurements.
Full Sonus Faber Sonetto II G2 review and specifications →
| Bass Extension (-10dB) | 38Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 62Hz (measured, Erin's Audio Corner) |
| Dimensions | 16.3"H x 8.9"W x 14"D (414.3 x 227.0 x 355.6 mm) |
| Drivers | 1x 6.5" mid-woofer (paper cone), 1x 1.1" (28mm) DAD soft dome tweeter |
| Impedance | 4 ohms nominal (4.2 ohms minimum, measured by Erin's Audio Corner) |
| Sensitivity | 87dB (measured, Erin's Audio Corner) |
| Spinorama Preference Score | 3.34 |
| Spinorama Preference Score with Perfect Sub | 5.62 |
| Weight | 38.4 lbs (17.4 kg) |
| Woofer Cabinet | ported, front |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Sonus Faber Sonetto II G2 vs Audio Craftsmen Victoria
- Sonus Faber Sonetto II G2 vs Pylon Jasper Monitor 18
- Sonus Faber Sonetto II G2 vs KEF Q350
- Sonus Faber Sonetto II G2 vs Emotiva Airmotiv B2+
- Sonus Faber Sonetto II G2 vs Sonus Faber Lumina II Amator
- Sonus Faber Sonetto II G2 vs JBL XPL-90
- Sonus Faber Sonetto II G2 vs Polk Reserve R100
- Sonus Faber Sonetto II G2 vs Klipsch RP-600M
- See all 59 comparisons
Dynaudio Contour 20i: $5750 per pair Safeandsoundhq eBay
Pros: Two-way design with a 1.125” Esotar2i silk dome tweeter and a 7” magnesium silicate polymer woofer in a vented enclosure. A shallow bass rolloff profile lets it sit closer to a wall (about 1-2 feet worked best in testing) without becoming boomy, and makes subwoofer integration comparatively easy. Very wide horizontal radiation (about ±70° through the midrange) gives an enveloping, spacious sound in a suitably sized room. On-axis response holds within about ±3dB overall and ±1.5dB through the midrange. Attractive build quality with a distinctive metal front baffle and gloss finish options. Long-term compression stays good up to 96dB, and short-term compression is within about 0.5dB at that same level. Measured bass extension of 56Hz (-3dB).
Cons: Notably room-dependent: sounds too bright in the lower treble in smaller rooms with close sidewalls, needing sidewall absorption to sound neutral, while performing better in larger or more open rooms without that treatment. A roughly 2dB lift in the lower treble combined with wide dispersion means more energy reflecting off sidewalls than some listeners will prefer. Relatively low sensitivity (about 82.5dB measured). Unusually sensitive to amplifier output impedance - high-output-impedance amps like tube or SET designs introduce up to a 2dB dip in the midrange, making the sound more mellow rather than “warmer,” the opposite of what many tube-amp buyers expect. Elevated harmonic and multitone distortion around 700Hz, which the reviewer attributes to typical cone-edge/surround behavior common across many driver brands, though it stands out on the measurement graphs. An upper-midrange dip around 2kHz can reduce attack and clarity on vocals and brass instruments. Vertical listening window is fairly narrow (roughly -20° to +30°) - moving outside that range causes a noticeable tonal shift, unlike coaxial designs that tolerate more vertical movement.
Full Dynaudio Contour 20i review and specifications →
| Bass Extension (-10dB) | 32Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 56Hz (measured, Erin's Audio Corner) |
| Dimensions | 17.4"H x 8.5"W x 14.2"D (442 x 215.9 x 360.7 mm) |
| Drivers | 18 cm MSP woofer, 28mm Esotar 2i with Hexis tweeter |
| Impedance | 4 ohms |
| Sensitivity | 82.5dB |
| Weight | 30.9 lbs (14 kg) each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Dynaudio Contour 20i vs SVS Ultra Bookshelf
- Dynaudio Contour 20i vs Technics SB-C700
- Dynaudio Contour 20i vs Definitive Technology Demand D11
- Dynaudio Contour 20i vs Yamaha NS-800A
- Dynaudio Contour 20i vs ELAC DBR62
- Dynaudio Contour 20i vs Infinity Reference R162
- Dynaudio Contour 20i vs ELAC Uni-Fi Reference UBR62
- Dynaudio Contour 20i vs Ascend CBM-170 SE2
- See all 57 comparisons