Short answer: the AsciLab F6Bs. It ranks #20 of 130 bookshelf speakers by sound quality at $799; the Sonus Faber Sonetto II G2 ranks #103 and costs $3500, so there is not much of a tradeoff to weigh.
What the Sonus Faber Sonetto II G2 offers: Two-way design with a 1.125” damped Apex Dome silk tweeter and 6.5” cone woofer, using a base of concrete, aluminum, and steel with under-cabinet venting. Notably more neutral than Sonus Faber’s own Lumina 2, which runs 2-5dB hotter in the treble. Horizontal directivity narrows at a fairly constant, well-behaved rate rather than narrowing-then-widening-then-narrowing like some rivals (including the Lumina 2), meaning sidewall reflections match the direct sound well enough that the reviewer doesn’t recommend sidewall absorption for this speaker. The tweeter-to-woofer crossover handoff around 3kHz looks clean, suggesting a higher-order crossover than typical for the size/price class. Good dynamic range - the low end loses only about 2dB from 76dB to 96dB, otherwise holding up well. Not a difficult amplifier load (about 4.2 ohms minimum impedance). Bass extension reaches a genuine 50Hz in-room, fuller than the Lumina 2. Watch for: Sounds notably bright pointed directly on-axis; toeing the speaker out about 30° reduces treble energy and sibilance meaningfully. A resonance around 700Hz gives vocals a slightly nasal, hollow quality. A dip in the upper midrange (roughly 1-2kHz) reduces perceived detail and attack, while the elevated treble can read as “analytical” or “detailed” to some listeners despite being a coloration rather than true resolution. Needs more clearance from the rear wall than some rivals - about 1.5-2 feet in an ideal room, more or less depending on your specific room modes - or the 80-120Hz region can become boomy. Vertical listening window is limited to about ±10-15° from the tweeter axis. Some unexplained directivity irregularities appear around 1.2kHz and 1.6kHz, possibly port-related, along with a longer decay in the 800Hz-1600Hz range in burst-decay measurements. Multitone distortion approaches the reviewer’s 3% threshold through the midrange, though likely not obviously audible without direct A/B comparison. A resonance in the cabinet appears around 400Hz in impedance measurements.
What the AsciLab F6Bs offers: A slimmer, sealed, VESA 100 wall mountable variant of AsciLab’s F6B, trading the F6B’s passive radiator for a shallower 15.4cm deep cabinet that can go straight on a wall bracket. The sound power directivity index has the tightest standard deviation, 3.32, of anything in this batch of new additions, meaning off axis energy tracks the on axis response unusually consistently for a sealed 2-way this size, and on axis deviation measures a clean 0.25dB average. Watch for: AsciLab’s own site shows the F6Bs sold out, though it remains in stock through resellers like Audiophonics and Tested Audio. Bass extension is measured at 82.0Hz at -3dB, noticeably less than the passive radiator equipped F6B, and listening window smoothness measures only a moderate 0.39. The 4 ohm nominal impedance calls for a reasonably capable amplifier.
Buy the AsciLab F6Bs. It ranks higher for sound quality than the Sonus Faber Sonetto II G2 and costs less, so there is no real case for the other one.
The Sonus Faber Sonetto II G2 is not a sound-quality pick. It sits near the bottom of the 130 bookshelf speakers; there are better options higher up.
Looking for alternatives? See the complete Passive Home rankings.
Specifications Side By Side
| Sonus Faber Sonetto II G2 | AsciLab F6Bs | |
|---|---|---|
| Price | $3500 per pair | €799 per pair |
| Ranked | #103 of 130 in Large Size Bookshelf Speakers | #20 of 130 in Large Size Bookshelf Speakers |
| Bass Extension (-10dB) | 38Hz (measured, Erin's Audio Corner) | 50.1Hz (measured, Audio Science Review) |
| Bass Extension (-3dB) | 62Hz (measured, Erin's Audio Corner) | 82.0Hz (measured, Audio Science Review) |
| Impedance | 4 ohms nominal (4.2 ohms minimum, measured by Erin's Audio Corner) | 4 ohms nominal, 3.7 ohms minimum |
| Sensitivity | 87dB (measured, Erin's Audio Corner) | 85.2dB @ 2.83V/1m (measured, Audio Science Review) |
| Drivers | 1x 6.5" mid-woofer (paper cone), 1x 1.1" (28mm) DAD soft dome tweeter | 1" aluminum dome tweeter with waveguide and phase plug, 6" fiber cone woofer |
| Weight | 38.4 lbs (17.4 kg) | 12.3 lbs (5.6 kg) each |
| Dimensions | 16.3"H x 8.9"W x 14"D (414.3 x 227.0 x 355.6 mm) | 14.5"H x 8"W x 6.1"D (368 x 203 x 154 mm) |
| Woofer Cabinet | ported, front | - |
| Spinorama Preference Score | 3.34 | 4.35 |
| Spinorama Preference Score with Perfect Sub | 5.62 | 7.01 |
| Enclosure | - | sealed |
| Crossover Frequency | - | 1kHz |
| Mounting | - | VESA 100 wall mount compatible |
| Warranty | - | 2 years |
| Country | - | South Korea |
| Maximum SPL | - | 100dB full bandwidth, 102dB above 100Hz (manufacturer specified) |
Related Speaker Comparisons
How AsciLab F6Bs compares with other leading options:
- AsciLab F6Bs vs Perlisten S4b
- AsciLab F6Bs vs KEF Reference 1 Meta
- AsciLab F6Bs vs GR-Research NX-Studio
- AsciLab C6B vs AsciLab F6Bs
- Audio First Cadentia 3 vs AsciLab F6Bs
Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Sonus Faber Sonetto II G2: $3500 per pair Crutchfield eBay
Pros: Two-way design with a 1.125” damped Apex Dome silk tweeter and 6.5” cone woofer, using a base of concrete, aluminum, and steel with under-cabinet venting. Notably more neutral than Sonus Faber’s own Lumina 2, which runs 2-5dB hotter in the treble. Horizontal directivity narrows at a fairly constant, well-behaved rate rather than narrowing-then-widening-then-narrowing like some rivals (including the Lumina 2), meaning sidewall reflections match the direct sound well enough that the reviewer doesn’t recommend sidewall absorption for this speaker. The tweeter-to-woofer crossover handoff around 3kHz looks clean, suggesting a higher-order crossover than typical for the size/price class. Good dynamic range - the low end loses only about 2dB from 76dB to 96dB, otherwise holding up well. Not a difficult amplifier load (about 4.2 ohms minimum impedance). Bass extension reaches a genuine 50Hz in-room, fuller than the Lumina 2. Measured bass extension of 62Hz (-3dB), with a measured sensitivity of 87dB.
Cons: Sounds notably bright pointed directly on-axis; toeing the speaker out about 30° reduces treble energy and sibilance meaningfully. A resonance around 700Hz gives vocals a slightly nasal, hollow quality. A dip in the upper midrange (roughly 1-2kHz) reduces perceived detail and attack, while the elevated treble can read as “analytical” or “detailed” to some listeners despite being a coloration rather than true resolution. Needs more clearance from the rear wall than some rivals - about 1.5-2 feet in an ideal room, more or less depending on your specific room modes - or the 80-120Hz region can become boomy. Vertical listening window is limited to about ±10-15° from the tweeter axis. Some unexplained directivity irregularities appear around 1.2kHz and 1.6kHz, possibly port-related, along with a longer decay in the 800Hz-1600Hz range in burst-decay measurements. Multitone distortion approaches the reviewer’s 3% threshold through the midrange, though likely not obviously audible without direct A/B comparison. A resonance in the cabinet appears around 400Hz in impedance measurements.
Full Sonus Faber Sonetto II G2 review and specifications →
| Bass Extension (-10dB) | 38Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 62Hz (measured, Erin's Audio Corner) |
| Dimensions | 16.3"H x 8.9"W x 14"D (414.3 x 227.0 x 355.6 mm) |
| Drivers | 1x 6.5" mid-woofer (paper cone), 1x 1.1" (28mm) DAD soft dome tweeter |
| Impedance | 4 ohms nominal (4.2 ohms minimum, measured by Erin's Audio Corner) |
| Sensitivity | 87dB (measured, Erin's Audio Corner) |
| Spinorama Preference Score | 3.34 |
| Spinorama Preference Score with Perfect Sub | 5.62 |
| Weight | 38.4 lbs (17.4 kg) |
| Woofer Cabinet | ported, front |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Sonus Faber Sonetto II G2 vs Audio Craftsmen Victoria
- Sonus Faber Sonetto II G2 vs Pylon Jasper Monitor 18
- Sonus Faber Sonetto II G2 vs KEF Q350
- Sonus Faber Sonetto II G2 vs Emotiva Airmotiv B2+
- Sonus Faber Sonetto II G2 vs Sonus Faber Lumina II Amator
- Sonus Faber Sonetto II G2 vs JBL XPL-90
- Sonus Faber Sonetto II G2 vs Polk Reserve R100
- Sonus Faber Sonetto II G2 vs Klipsch RP-600M
- See all 59 comparisons
AsciLab F6Bs: €799 per pair Audiophonics eBay
Pros: A slimmer, sealed, VESA 100 wall mountable variant of AsciLab’s F6B, trading the F6B’s passive radiator for a shallower 15.4cm deep cabinet that can go straight on a wall bracket. The sound power directivity index has the tightest standard deviation, 3.32, of anything in this batch of new additions, meaning off axis energy tracks the on axis response unusually consistently for a sealed 2-way this size, and on axis deviation measures a clean 0.25dB average. Measured bass extension of 82.0Hz (-3dB), with a measured sensitivity of 85.2dB.
Cons: AsciLab’s own site shows the F6Bs sold out, though it remains in stock through resellers like Audiophonics and Tested Audio. Bass extension is measured at 82.0Hz at -3dB, noticeably less than the passive radiator equipped F6B, and listening window smoothness measures only a moderate 0.39. The 4 ohm nominal impedance calls for a reasonably capable amplifier.
Full AsciLab F6Bs review and specifications →
| Bass Extension (-10dB) | 50.1Hz (measured, Audio Science Review) |
|---|---|
| Bass Extension (-3dB) | 82.0Hz (measured, Audio Science Review) |
| Country | South Korea |
| Crossover Frequency | 1kHz |
| Dimensions | 14.5"H x 8"W x 6.1"D (368 x 203 x 154 mm) |
| Drivers | 1" aluminum dome tweeter with waveguide and phase plug, 6" fiber cone woofer |
| Enclosure | sealed |
| Impedance | 4 ohms nominal, 3.7 ohms minimum |
| Maximum SPL | 100dB full bandwidth, 102dB above 100Hz (manufacturer specified) |
| Mounting | VESA 100 wall mount compatible |
| Sensitivity | 85.2dB @ 2.83V/1m (measured, Audio Science Review) |
| Spinorama Preference Score | 4.35 |
| Spinorama Preference Score with Perfect Sub | 7.01 |
| Warranty | 2 years |
| Weight | 12.3 lbs (5.6 kg) each |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- AsciLab F6Bs vs Epos ES14N
- AsciLab F6Bs vs Arendal 1528 Monitor 8
- AsciLab F6Bs vs MoFi SourcePoint 8
- AsciLab F6Bs vs Ascend Acoustics CMT-340 SE2
- AsciLab F6Bs vs Wharfedale Super Linton
- AsciLab F6Bs vs Buchardt Audio E50
- AsciLab F6Bs vs KEF R3
- AsciLab F6Bs vs MoFi SourcePoint 10
- See all 45 comparisons