Short answer: the KEF Blade Two Meta for better sound quality, the Polk Audio XT60 for the lower price. The KEF Blade Two Meta ranks #2 of 71 floorstanding speakers at $28000. The Polk Audio XT60 ranks #43 at $209, $27791 cheaper.
What the Polk Audio XT60 offers: Passive-radiator-loaded design (6.5” woofer plus two 6.5” passive radiators) gives deeper bass than the driver size alone would suggest - 43.9Hz at -3dB / 38.1Hz at -10dB, genuinely competitive extension for a budget tower. Hi-Res Audio certified, Dolby Atmos/DTS:X compatible, and works with either 4- or 8-ohm amplifier outputs. Watch for: Bass alignment Q (lfq 0.96) is the highest, least-controlled figure in this entire batch, consistent with owner reports of a slightly loose, boomy low end at higher volumes. On-axis deviation (nbd_on_axis 0.512) is also the roughest measured figure in the batch. The vinyl-wrapped (not wood veneer) cabinet reads as budget up close per owner reviews, and at least one owner reported blowing a driver under sustained heavy bass - some caution is warranted with bass-heavy source material at volume.
What the KEF Blade Two Meta offers: True point-source coaxial design (four 6.5in mid-bass drivers flanking a coincident mid/tweeter) with matched ~50 degree horizontal and vertical dispersion, unusual for a multi-driver speaker. Fully rounded, edgeless cabinet eliminates baffle diffraction. Frequency response holds within about 2.5dB across the listening window. Extremely low harmonic and multitone distortion even at 96dB, with under 0.5dB of compression at full output, rivaling the Reference 1 Meta and JBL 4367 in dynamic range. Reviewer described the imaging and soundstage depth as revealing recording details other speakers he tested (PS Audio FR10, MoFi SourcePoint 8, Neumann KH80) masked. Available in any custom finish at no extra charge. Watch for: 2dB dip and slight resonance around 200Hz, also visible in KEF white paper and likely cabinet-related. Bass rolls off fairly quickly below its 31Hz F3. Horizontal dispersion (~50 degrees) is narrower than the reviewer preferred 70-80 degrees; benefits from toeing out 10-20 degrees to open soundstage without losing image focus. Needs a separate power amp, not AVR-friendly.
Buy the Polk Audio XT60 if the price is the priority over sound quality, or the KEF Blade Two Meta if sound quality is the priority over the price.
Looking for alternatives? See the complete Passive Home rankings.
Specifications Side By Side
| Polk Audio XT60 | KEF Blade Two Meta | |
|---|---|---|
| Price | $209.00 per pair | $28000 per pair only sold in stores |
| Ranked | #43 of 71 in Large Size Floorstanding Speakers | #2 of 71 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 38.1Hz (measured, spinorama.org) | 26Hz (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 43.9Hz (measured, spinorama.org) | 31Hz (measured, Erin's Audio Corner) |
| Impedance | 4/8-ohm compatible | 4 ohms nominal (3.3 ohms minimum, measured, Erin's Audio Corner) |
| Sensitivity | 86dB (1W/1m) | 86.8dB (measured, Erin's Audio Corner) |
| Drivers | 1" Terylene dome tweeter, 6.5" bilaminate polypropylene woofer, 2x 6.5" passive radiators | 4 x 165 mm (6.5 in.) aluminium cone, force cancelling woofers, 125 mm (5 in.) aluminium cone midrange, 25 mm (1 in.) aluminium dome with MAT tweeter |
| Weight | 20 lbs (9.07 kg) each | 79.4 lbs (36 kg) each |
| Woofer Cabinet | Passive radiator-loaded | ported, rear |
| Dimensions | 19.05 x 92.5 x 23.09cm (7.5 x 36.4 x 9.09 in) each | 46.6"H x 13.5"W x 14.8"D (1183.6 x 342.9 x 375.9 mm) |
| Spinorama Preference Score | 4.28 | 6.25 |
| Spinorama Preference Score with Perfect Sub | 6.23 | 7.37 |
Related Speaker Comparisons
How KEF Blade Two Meta compares with other leading options:
- GR-Research NX-Treme vs KEF Blade Two Meta
- KEF Blade Two Meta vs MoFi SourcePoint V10 Master Edition
- KEF Blade Two Meta vs MoFi SourcePoint 888
- Radiant Acoustics Clarity 66 vs KEF Blade Two Meta
- Ascend Acoustics ELX Ribbon Tower vs KEF Blade Two Meta
Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Polk Audio XT60: $209.00 per pair Amazon B&H Photo Video Crutchfield eBay
Pros: Passive-radiator-loaded design (6.5” woofer plus two 6.5” passive radiators) gives deeper bass than the driver size alone would suggest - 43.9Hz at -3dB / 38.1Hz at -10dB, genuinely competitive extension for a budget tower. Hi-Res Audio certified, Dolby Atmos/DTS:X compatible, and works with either 4- or 8-ohm amplifier outputs. Measured bass extension of 43.9Hz (-3dB).
Cons: Bass alignment Q (lfq 0.96) is the highest, least-controlled figure in this entire batch, consistent with owner reports of a slightly loose, boomy low end at higher volumes. On-axis deviation (nbd_on_axis 0.512) is also the roughest measured figure in the batch. The vinyl-wrapped (not wood veneer) cabinet reads as budget up close per owner reviews, and at least one owner reported blowing a driver under sustained heavy bass - some caution is warranted with bass-heavy source material at volume.
Full Polk Audio XT60 review and specifications →
| Bass Extension (-10dB) | 38.1Hz (measured, spinorama.org) |
|---|---|
| Bass Extension (-3dB) | 43.9Hz (measured, spinorama.org) |
| Dimensions | 19.05 x 92.5 x 23.09cm (7.5 x 36.4 x 9.09 in) each |
| Drivers | 1" Terylene dome tweeter, 6.5" bilaminate polypropylene woofer, 2x 6.5" passive radiators |
| Impedance | 4/8-ohm compatible |
| Sensitivity | 86dB (1W/1m) |
| Spinorama Preference Score | 4.28 |
| Spinorama Preference Score with Perfect Sub | 6.23 |
| Weight | 20 lbs (9.07 kg) each |
| Woofer Cabinet | Passive radiator-loaded |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Polk Audio XT60 vs Klipsch Heresy IV
- Polk Audio XT60 vs Klipsch Forte IV
- Polk Audio XT60 vs KEF Q11 Meta
- Polk Audio XT60 vs Definitive Technology BP-9020
- Polk Audio XT60 vs Klipsch RP-5000F II
- Polk Audio XT60 vs Polk Reserve R500
- Polk Audio XT60 vs ELAC Debut 3.0 DF63
- Polk Audio XT60 vs PSB Imagine T65
- See all 35 comparisons
KEF Blade Two Meta: $28000 per pair only sold in stores eBay
Pros: True point-source coaxial design (four 6.5in mid-bass drivers flanking a coincident mid/tweeter) with matched ~50 degree horizontal and vertical dispersion, unusual for a multi-driver speaker. Fully rounded, edgeless cabinet eliminates baffle diffraction. Frequency response holds within about 2.5dB across the listening window. Extremely low harmonic and multitone distortion even at 96dB, with under 0.5dB of compression at full output, rivaling the Reference 1 Meta and JBL 4367 in dynamic range. Reviewer described the imaging and soundstage depth as revealing recording details other speakers he tested (PS Audio FR10, MoFi SourcePoint 8, Neumann KH80) masked. Available in any custom finish at no extra charge. Measured bass extension of 31Hz (-3dB), with a measured sensitivity of 86.8dB.
Cons: 2dB dip and slight resonance around 200Hz, also visible in KEF white paper and likely cabinet-related. Bass rolls off fairly quickly below its 31Hz F3. Horizontal dispersion (~50 degrees) is narrower than the reviewer preferred 70-80 degrees; benefits from toeing out 10-20 degrees to open soundstage without losing image focus. Needs a separate power amp, not AVR-friendly.
Full KEF Blade Two Meta review and specifications →
| Bass Extension (-10dB) | 26Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 31Hz (measured, Erin's Audio Corner) |
| Dimensions | 46.6"H x 13.5"W x 14.8"D (1183.6 x 342.9 x 375.9 mm) |
| Drivers | 4 x 165 mm (6.5 in.) aluminium cone, force cancelling woofers, 125 mm (5 in.) aluminium cone midrange, 25 mm (1 in.) aluminium dome with MAT tweeter |
| Impedance | 4 ohms nominal (3.3 ohms minimum, measured, Erin's Audio Corner) |
| Sensitivity | 86.8dB (measured, Erin's Audio Corner) |
| Spinorama Preference Score | 6.25 |
| Spinorama Preference Score with Perfect Sub | 7.37 |
| Weight | 79.4 lbs (36 kg) each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- KEF Blade Two Meta vs GR-Research NX-Treme
- KEF Blade Two Meta vs MoFi SourcePoint V10 Master Edition
- KEF Blade Two Meta vs MoFi SourcePoint 888
- KEF Blade Two Meta vs Radiant Acoustics Clarity 66
- KEF Blade Two Meta vs Ascend Acoustics ELX Ribbon Tower
- KEF Blade Two Meta vs JBL HDI-3800
- KEF Blade Two Meta vs Revel F328Be
- KEF Blade Two Meta vs KEF R5 Meta
- See all 35 comparisons