Neumann KH80 DSP vs Vanatoo Transparent One Encore Plus

Last updated: August 24, 2026

Short answer: the Neumann KH80 DSP. It ranks #7 of 58 powered bookshelf speakers by sound quality at $598.98; the Vanatoo Transparent One Encore Plus ranks #32 and costs $699.99, so there is not much of a tradeoff to weigh.

What the Neumann KH80 DSP offers: Compact 2-way nearfield monitor - a 1” tweeter in an elliptical waveguide over a 4” mid-woofer, crossed over around 1.8kHz with steep 48dB/octave slopes. Exceptionally linear on-axis response, within about ±1.5dB, with essentially nothing worth equalizing beyond a minor, likely port-related wrinkle around 800Hz. Vertical dispersion is unusually wide and consistent for a monitor this size, holding together to roughly ±40° versus the ±20° or so typical of similarly compact designs - a benefit of the steep crossover slopes and waveguide minimizing comb filtering, so listening height and seating posture matter less than on most small monitors. Back-panel switches (freestanding, small/medium/large desk) tailor the low-mid response to compensate for desk-boundary reflections. Distortion in the midrange doesn’t change when high-passed to a subwoofer at 80Hz, showing the drivers already have a clean distortion profile on their own. Maintains good composure and linearity up to about 96dB SPL down to roughly 80Hz before an active protection circuit engages; tested with dense multitone program material rather than a sine sweep, output around 96dB costs only about 1dB in the midrange, putting realistic maximum SPL near 95dB. Watch for: High price for its size, at roughly $1,000/pair. The horizontal pattern stays wide and essentially constant out to about ±30° before beaming and narrowing further out (then flattening again near 2kHz) - a wide, controlled pattern in absolute terms, but one that reflects more high-frequency energy off nearby sidewalls than a narrower design would. At greater listening distances or in more reflective rooms (tested around 6 feet away at 75-80dB), that shows up as a top end that reads a bit hot despite the speaker measuring essentially flat on-axis - a byproduct of its directivity rather than its tonal balance, and mostly moot for genuine nearfield desktop use inside about a meter. The estimated in-room response shows a shallow dip around 1-2kHz and a treble trend running 2-3dB above the midrange in that same far-field estimate. Multitone distortion for a single speaker climbs into the 3-5% range at 96dB SPL, though that’s only really relevant well above typical nearfield listening levels. Bass rolls off below its F3 of 57Hz (F10 48Hz), so the 4” mid-woofer still needs a subwoofer for real low-end content. The companion app for EQ/setup is iPad-only, with no Android or Bluetooth option despite being control-only, and the in-room calibration microphone is a separate purchase in most cases. In a separate comparison test, the smoother-measuring KH80 actually sounded smaller and less present than the cheaper JBL 305P MKII, which had more perceived bass and clarity despite measuring worse on paper.

What the Vanatoo Transparent One Encore Plus offers: Smooth, relatively flat on-axis response instead of the pronounced mid-bass-and-treble “V curve” common in this size class, which tends to cause listener fatigue over long sessions. A waveguide plus phase plug on the tweeter helps spread off-axis energy more evenly, giving good vertical consistency. Included remote controls volume, source, and separate treble/mid-bass trim, letting you tune the tonal balance without a computer or app. Subwoofer output with automatic 80/125 Hz crossover engagement when a sub is connected. Extensive wired inputs: USB, optical, coax, and analog, plus Bluetooth. 240W total power is enough headroom for near-field desktop use or a small-to-medium living room. Watch for: A slight sibilance/edge in the 4-6 kHz lower-treble region stood out to the reviewer as mildly fatiguing, though a single band of parametric EQ (about -2dB) fixed it; toeing the speakers off-axis reduces but doesn’t eliminate it. A minor scoop in the 1-2 kHz mid-range is audible in A/B comparison but not problematic on its own. No HDMI input, a drawback if you want to use these as TV speakers via ARC. Like most stand-mount speakers this size, real output below about 40 Hz needs a subwoofer - the reviewer recommends pairing one regardless of use case just to take headroom pressure off the mains.

Buy the Neumann KH80 DSP. It ranks higher for sound quality than the Vanatoo Transparent One Encore Plus and costs less, so there is no real case for the other one.

Neumann KH80 DSP vs Vanatoo Transparent One Encore Plus

Specifications Side By Side

Neumann KH80 DSP Vanatoo Transparent One Encore Plus
Price$598.98$699.99
Ranked#7 of 58 in Medium Size Powered Bookshelf Speakers#32 of 58 in Medium Size Powered Bookshelf Speakers
Dimensions13.6"H x 10.8"W x 9.6"D (345.4 x 274.3 x 243.8 mm)10"H x 6.5"W x 8"D (254 x 165 x 203mm)
Frequency Response57 Hz - 25 kHz (+-3 dB) (Manufacturer specified)48Hz - 20kHz ±3dB (manufacturer specified, Flat mode)
InputsXLRUSB, Optical, Coax, Analog, Bluetooth
Weight9 lbs / 4.1 kg each10.8 lbs (passive unit), 12.2 lbs (active unit)
Drivers4.1" woofer, 1" fabric dome tweeter5.25" aluminum-cone woofer with XBL motor, 5.25" passive radiator (rear), 1" aluminum dome tweeter with waveguide and phase plug
AppYes (MA 1 alignment)-
Bass Extension (-10dB)51Hz (measured, Erin’s Audio Corner)34Hz (measured, Erin’s Audio Corner)
Bass Extension (-3dB)57Hz (measured, Erin’s Audio Corner)42Hz (measured, Erin’s Audio Corner)
BluetoothNo-
DSPYes-
EQYes (via DSP)-
Max SPL110.7dB @ 1m-
Sensitivity91.9dB (measured at 0.3V/1m, Erin’s Audio Corner)-
Output Power140W (90W woofer + 50W tweeter)240W total (100W + 20W Class D amplifiers per enclosure)

More useful head-to-heads from the same speaker class:

Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.

As an eBay Partner, we may be compensated if you make a purchase.

The Two Speakers In Full

Neumann KH80 DSP: $598.98 Amazon Bhphotovideo eBay

Neumann KH80 DSP ranking card

Pros: Compact 2-way nearfield monitor - a 1” tweeter in an elliptical waveguide over a 4” mid-woofer, crossed over around 1.8kHz with steep 48dB/octave slopes. Exceptionally linear on-axis response, within about ±1.5dB, with essentially nothing worth equalizing beyond a minor, likely port-related wrinkle around 800Hz. Vertical dispersion is unusually wide and consistent for a monitor this size, holding together to roughly ±40° versus the ±20° or so typical of similarly compact designs - a benefit of the steep crossover slopes and waveguide minimizing comb filtering, so listening height and seating posture matter less than on most small monitors. Back-panel switches (freestanding, small/medium/large desk) tailor the low-mid response to compensate for desk-boundary reflections. Distortion in the midrange doesn’t change when high-passed to a subwoofer at 80Hz, showing the drivers already have a clean distortion profile on their own. Maintains good composure and linearity up to about 96dB SPL down to roughly 80Hz before an active protection circuit engages; tested with dense multitone program material rather than a sine sweep, output around 96dB costs only about 1dB in the midrange, putting realistic maximum SPL near 95dB.

Cons: High price for its size, at roughly $1,000/pair. The horizontal pattern stays wide and essentially constant out to about ±30° before beaming and narrowing further out (then flattening again near 2kHz) - a wide, controlled pattern in absolute terms, but one that reflects more high-frequency energy off nearby sidewalls than a narrower design would. At greater listening distances or in more reflective rooms (tested around 6 feet away at 75-80dB), that shows up as a top end that reads a bit hot despite the speaker measuring essentially flat on-axis - a byproduct of its directivity rather than its tonal balance, and mostly moot for genuine nearfield desktop use inside about a meter. The estimated in-room response shows a shallow dip around 1-2kHz and a treble trend running 2-3dB above the midrange in that same far-field estimate. Multitone distortion for a single speaker climbs into the 3-5% range at 96dB SPL, though that’s only really relevant well above typical nearfield listening levels. Bass rolls off below its F3 of 57Hz (F10 48Hz), so the 4” mid-woofer still needs a subwoofer for real low-end content. The companion app for EQ/setup is iPad-only, with no Android or Bluetooth option despite being control-only, and the in-room calibration microphone is a separate purchase in most cases. In a separate comparison test, the smoother-measuring KH80 actually sounded smaller and less present than the cheaper JBL 305P MKII, which had more perceived bass and clarity despite measuring worse on paper.

AppYes (MA 1 alignment)
Bass Extension (-10dB)51Hz (measured, Erin's Audio Corner)
Bass Extension (-3dB)57Hz (measured, Erin's Audio Corner)
BluetoothNo
DSPYes
Dimensions13.6"H x 10.8"W x 9.6"D (345.4 x 274.3 x 243.8 mm)
Drivers4.1" woofer, 1" fabric dome tweeter
EQYes (via DSP)
Frequency Response57 Hz - 25 kHz (+-3 dB) (Manufacturer specified)
InputsXLR
Max SPL110.7dB @ 1m
Output Power140W (90W woofer + 50W tweeter)
Sensitivity91.9dB (measured at 0.3V/1m, Erin's Audio Corner)
Weight9 lbs / 4.1 kg each

Vanatoo Transparent One Encore Plus: $699.99 Amazon eBay

Vanatoo Transparent One Encore Plus ranking card

Pros: Smooth, relatively flat on-axis response instead of the pronounced mid-bass-and-treble “V curve” common in this size class, which tends to cause listener fatigue over long sessions. A waveguide plus phase plug on the tweeter helps spread off-axis energy more evenly, giving good vertical consistency. Included remote controls volume, source, and separate treble/mid-bass trim, letting you tune the tonal balance without a computer or app. Subwoofer output with automatic 80/125 Hz crossover engagement when a sub is connected. Extensive wired inputs: USB, optical, coax, and analog, plus Bluetooth. 240W total power is enough headroom for near-field desktop use or a small-to-medium living room.

Cons: A slight sibilance/edge in the 4-6 kHz lower-treble region stood out to the reviewer as mildly fatiguing, though a single band of parametric EQ (about -2dB) fixed it; toeing the speakers off-axis reduces but doesn’t eliminate it. A minor scoop in the 1-2 kHz mid-range is audible in A/B comparison but not problematic on its own. No HDMI input, a drawback if you want to use these as TV speakers via ARC. Like most stand-mount speakers this size, real output below about 40 Hz needs a subwoofer - the reviewer recommends pairing one regardless of use case just to take headroom pressure off the mains.

Bass Extension (-10dB)34Hz (measured, Erin's Audio Corner)
Bass Extension (-3dB)42Hz (measured, Erin's Audio Corner)
Dimensions10"H x 6.5"W x 8"D (254 x 165 x 203mm)
Drivers5.25" aluminum-cone woofer with XBL motor, 5.25" passive radiator (rear), 1" aluminum dome tweeter with waveguide and phase plug
Frequency Response48Hz - 20kHz ±3dB (manufacturer specified, Flat mode)
InputsUSB, Optical, Coax, Analog, Bluetooth
Output Power240W total (100W + 20W Class D amplifiers per enclosure)
Weight10.8 lbs (passive unit), 12.2 lbs (active unit)