Short answer: the KEF R11 Meta for better sound quality, the Klipsch RP-8000F II for the lower price. The KEF R11 Meta ranks #26 of 68 floorstanding speakers at $3499.99. The Klipsch RP-8000F II ranks #52 at $1800, $1699.99 cheaper.
What the KEF R11 Meta offers: CEA2034 spinorama shows a generally flat on-axis response with good directivity and very deep bass extension (F10 of 30Hz). Predicted in-room response is very smooth aside from the small 1-1.5kHz dip. The coaxial Uni-Q driver gives excellent, symmetric vertical directivity, unusual for a tower speaker. Distortion is incredibly low even down to 30Hz at 86dB SPL/1m, and stays low even at 96dB and 102dB SPL/1m - the reviewer found essentially no audible tonality change across that whole output range. Watch for: A dip around 1-1.2kHz on-axis is attributed to a diffraction effect, and shows up as a smaller dip in the predicted in-room response. Horizontal beamwidth of about ±40 degrees is on the narrower side, though the transition from wide to constant directivity is smooth. Minimum impedance dips to 3.2 ohms around 580Hz, calling for an amplifier comfortable with a demanding load. 4-ohm nominal impedance overall.
What the Klipsch RP-8000F II offers: Highest sensitivity of the RP II floorstander line (~92dB measured) and the best dynamics/compression behavior of the three under load - the cleanest at high output. Dual 8-inch woofers and the highest power handling in the line. Watch for: Mid-bass sounds lean despite the dual 8-inch woofers, and bass extension disappointed for its size - expected to reach 50Hz, didn’t get there in-room. Has its own edgy upper-mid bump (2-6kHz) that’s harder to EQ out than the other two models’ issues, since it stems from the vertical horn/woofer offset rather than simple tonal balance. The most placement-critical of the three, with the narrowest horizontal (~40-50 degrees) and vertical (+5/-10 degrees) dispersion.
Buy the KEF R11 Meta if sound quality matters more than the price. Buy the Klipsch RP-8000F II if the price matters more than sound quality.
If sound quality matters at all to you, skip the Klipsch RP-8000F II. It ranks near the bottom of the 68 floorstanding speakers, so look higher up the list instead.
Specifications Side By Side
| KEF R11 Meta | Klipsch RP-8000F II | |
|---|---|---|
| Price | $3,499.99 | $1800 |
| Ranked | #26 of 68 in Large Size Floorstanding Speakers | #52 of 68 in Large Size Floorstanding Speakers |
| Bass Extension (-10dB) | 31Hz (measured, Audio Science Review) | 33Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-3dB) | 64Hz (measured, Audio Science Review) | 67Hz (measured, Erin’s Audio Corner) |
| Dimensions | 51"H x 12.2"W x 15.1"D (1295.4 x 309.9 x 383.5 mm) | 43.1" x 10.8" x 18.3" (1095 x 275 x 464 mm) |
| Impedance | 4 ohms | 8 ohms nominal (3.7 ohms minimum above 80Hz, measured by Erin’s Audio Corner) |
| Drivers | 4 x 165 mm (6.5 in.) hybrid aluminium cone woofers, 125 mm (5 in.) aluminium cone midrange, 25 mm (1 in.) vented aluminium dome with MAT tweeter | 1" titanium tweeter with 90x90 Tractrix horn, dual 8" cerametallic woofers |
| Sensitivity | 89.5dB | 92dB (2.83V/1m, measured by Erin’s Audio Corner) |
| Weight | 80.5 lbs / 36.5 kg each | 61.3 lbs / 27.8 kg |
| Woofer Cabinet | ported, rear | ported, rear |
| Frequency Response | - | 35Hz - 25kHz (+-3dB, Manufacturer specified) |
| Crossover Frequency | - | 1630Hz |
| Output Power | - | 150W continuous, 600W peak |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- JBL HDI-3600 vs Dynaudio Emit 30
- Arendal 1961 Tower vs PSB Imagine T65
- SVS Ultra Evolution Pinnacle vs Dynaudio Emit 30
- KEF R11 Meta vs Revel F206
- JBL HDI-3600 vs Klipsch RP-8000F II
Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
KEF R11 Meta: $3,499.99 Amazon eBay
Pros: CEA2034 spinorama shows a generally flat on-axis response with good directivity and very deep bass extension (F10 of 30Hz). Predicted in-room response is very smooth aside from the small 1-1.5kHz dip. The coaxial Uni-Q driver gives excellent, symmetric vertical directivity, unusual for a tower speaker. Distortion is incredibly low even down to 30Hz at 86dB SPL/1m, and stays low even at 96dB and 102dB SPL/1m - the reviewer found essentially no audible tonality change across that whole output range.
Cons: A dip around 1-1.2kHz on-axis is attributed to a diffraction effect, and shows up as a smaller dip in the predicted in-room response. Horizontal beamwidth of about ±40 degrees is on the narrower side, though the transition from wide to constant directivity is smooth. Minimum impedance dips to 3.2 ohms around 580Hz, calling for an amplifier comfortable with a demanding load. 4-ohm nominal impedance overall.
Full KEF R11 Meta review and specifications →
| Bass Extension (-10dB) | 31Hz (measured, Audio Science Review) |
|---|---|
| Bass Extension (-3dB) | 64Hz (measured, Audio Science Review) |
| Dimensions | 51"H x 12.2"W x 15.1"D (1295.4 x 309.9 x 383.5 mm) |
| Drivers | 4 x 165 mm (6.5 in.) hybrid aluminium cone woofers, 125 mm (5 in.) aluminium cone midrange, 25 mm (1 in.) vented aluminium dome with MAT tweeter |
| Impedance | 4 ohms |
| Sensitivity | 89.5dB |
| Weight | 80.5 lbs / 36.5 kg each |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
Klipsch RP-8000F II: $1800 Amazon eBay
Pros: Highest sensitivity of the RP II floorstander line (~92dB measured) and the best dynamics/compression behavior of the three under load - the cleanest at high output. Dual 8-inch woofers and the highest power handling in the line.
Cons: Mid-bass sounds lean despite the dual 8-inch woofers, and bass extension disappointed for its size - expected to reach 50Hz, didn’t get there in-room. Has its own edgy upper-mid bump (2-6kHz) that’s harder to EQ out than the other two models’ issues, since it stems from the vertical horn/woofer offset rather than simple tonal balance. The most placement-critical of the three, with the narrowest horizontal (~40-50 degrees) and vertical (+5/-10 degrees) dispersion.
Full Klipsch RP-8000F II review and specifications →
| Bass Extension (-10dB) | 33Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 67Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 1630Hz |
| Dimensions | 43.1" x 10.8" x 18.3" (1095 x 275 x 464 mm) |
| Drivers | 1" titanium tweeter with 90x90 Tractrix horn, dual 8" cerametallic woofers |
| Frequency Response | 35Hz - 25kHz (+-3dB, Manufacturer specified) |
| Impedance | 8 ohms nominal (3.7 ohms minimum above 80Hz, measured by Erin's Audio Corner) |
| Output Power | 150W continuous, 600W peak |
| Sensitivity | 92dB (2.83V/1m, measured by Erin's Audio Corner) |
| Weight | 61.3 lbs / 27.8 kg |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Klipsch RP-8000F II vs Dynaudio Emit 30
- Klipsch RP-8000F II vs Klipsch RP-6000F II
- Klipsch RP-8000F II vs SVS Ultra Evolution Pinnacle
- Klipsch RP-8000F II vs Polk T50
- Klipsch RP-8000F II vs Klipsch RP-5000F II
- Klipsch RP-8000F II vs KLH Model Five
- Klipsch RP-8000F II vs KEF Q11 Meta
- Klipsch RP-8000F II vs Focal Aria Evo X N°2
- See all 29 comparisons