Short answer: the Wharfedale Super Denton for better sound quality, the KEF Q100 for the lower price. The Wharfedale Super Denton ranks #18 of 71 bookshelf speakers at $1499. The KEF Q100 ranks #53 at $550, $949 cheaper.
What the KEF Q100 offers: 5.25” Uni-Q coaxial driver keeps the tweeter and woofer point-source aligned for consistent imaging. 86dB sensitivity is reasonably easy to drive. Watch for: CEA2034 spinorama shows broad, audible deviations from flat rather than narrow peaks: a lift from 700Hz-1.5kHz and again from 5kHz up, plus a cancellation notch around 1.4kHz from port/cabinet interaction. Bass sensitivity drops to about 80dB and impedance falls below 4 ohms in the bass, demanding a capable amplifier. The reviewer heard boomy, buzzing bass that improved somewhat with the port plugged, and could not recommend it, calling the famous reputation more about looks than sound.
What the Wharfedale Super Denton offers: A 3-way design with a 1” soft dome tweeter, a 2” soft dome midrange offset to the side of a centered 6.5” woven Kevlar woofer - a more compact alternative to Wharfedale’s own Linton 85 with a similar overall character. Measured sensitivity around 86.6-87dB with on-axis linearity within about ±3dB. No cabinet or box resonances turned up in impedance testing, and there are no spike feet to install. Harmonic distortion looks good at both 86dB and 96dB, with about 20dB of usable dynamic range up to 96dB before compression starts to affect the midrange more noticeably near 102dB. Because bass rolls off starting around 60Hz, placing it closer to a wall (about 1-2 feet) than usual boosts low-end punch without the midbass bloat a deeper-extending speaker would get from the same placement. In the reviewer’s own comparison, its estimated in-room response actually measured more linear than the pricier Linton 85’s, despite being a bit less linear on-axis. Watch for: A mid-range scoop from about 200-800Hz and a separate upper-midrange scoop were both audible in direct ABX comparison against a reference-neutral speaker, giving aggressive-sounding material a more subdued character. A resonance around 660-700Hz shows up in measurement, though the reviewer couldn’t reliably hear it with real music in his own blind-ish A/B testing. The offset tweeter-and-midrange layout makes horizontal off-axis response noticeably asymmetric - response drops as much as 8dB more to one side than the other at wider angles - so the reviewer recommends aiming the speakers directly at the listener (not toed out, which loses upper treble) and suggests sidewall absorption to control uneven reflections. Must be listened to with the grille on - measurements are noticeably worse with it off (wider 2-4kHz dip, extra treble bump). Horizontal soundstage width felt a bit narrower than the reviewer personally prefers, likely related to the same offset driver layout. Multitone distortion gets high in the midrange at 96dB/1m, a concern mainly in larger rooms where you’d need to play louder.
Buy the KEF Q100 if the price matters more than sound quality. Buy the Wharfedale Super Denton if sound quality matters more than the price.
Specifications Side By Side
| KEF Q100 | Wharfedale Super Denton | |
|---|---|---|
| Price | $550 Discontinued | $1499 |
| Ranked | #53 of 71 in Medium Size Bookshelf Speakers | #18 of 71 in Medium Size Bookshelf Speakers |
| Bass Extension (-3dB) | 85Hz (measured, Audio Science Review) | 61Hz (measured, Erin’s Audio Corner) |
| Bass Extension (-10dB) | 65Hz (measured, Audio Science Review) | 41Hz (measured, Erin’s Audio Corner) |
| Discontinued | Yes | - |
| Sensitivity | 85dB (2.83V/1m, measured, Audio Science Review) | 86.6dB (measured by Erin’s Audio Corner) |
| Impedance | 8 ohms nominal | 6 ohms nominal, 3 ohms minimum (measured, Erin’s Audio Corner) |
| Frequency Response | 49Hz - 40kHz (+/-3dB) (Manufacturer specified) | 52Hz - 20kHz (±3dB, manufacturer specified); -6dB to 40Hz |
| Drivers | 5.25" Uni-Q aluminum coaxial driver, 1" aluminum dome tweeter | 1" soft dome tweeter, 2" soft dome midrange, 6.5" woven Kevlar woofer |
| Weight | 13 lbs / 5.9 kg each | 20.3 lbs / 9.2 kg (20.2 lbs) each |
| Dimensions | 11.8"H x 7.1"W x 10.7"D (300 x 180 x 272 mm) | 14.2"H x 9.7"W x 10.8"D (360 x 246 x 275 mm) |
| Woofer Cabinet | ported, rear | ported |
| Crossover Frequency | - | 940Hz, 4.6kHz |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Dynaudio X14 vs ELAC Uni-Fi 2.0 UB52
- KEF LS50 Meta vs Klipsch RP-500M II
- ELAC Uni-Fi 2.0 UB52 vs KEF LS50 Meta
- Dynaudio X14 vs KEF Q100
- Wharfedale Super Denton vs Wharfedale Diamond 12.1
Prices on this page were last checked August 24, 2026 at 6:53 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
KEF Q100: $550 Discontinued eBay
Pros: 5.25” Uni-Q coaxial driver keeps the tweeter and woofer point-source aligned for consistent imaging. 86dB sensitivity is reasonably easy to drive.
Cons: CEA2034 spinorama shows broad, audible deviations from flat rather than narrow peaks: a lift from 700Hz-1.5kHz and again from 5kHz up, plus a cancellation notch around 1.4kHz from port/cabinet interaction. Bass sensitivity drops to about 80dB and impedance falls below 4 ohms in the bass, demanding a capable amplifier. The reviewer heard boomy, buzzing bass that improved somewhat with the port plugged, and could not recommend it, calling the famous reputation more about looks than sound. Discontinued.
Full KEF Q100 review and specifications →
| Bass Extension (-10dB) | 65Hz (measured, Audio Science Review) |
|---|---|
| Bass Extension (-3dB) | 85Hz (measured, Audio Science Review) |
| Dimensions | 11.8"H x 7.1"W x 10.7"D (300 x 180 x 272 mm) |
| Discontinued | Yes |
| Drivers | 5.25" Uni-Q aluminum coaxial driver, 1" aluminum dome tweeter |
| Frequency Response | 49Hz - 40kHz (+/-3dB) (Manufacturer specified) |
| Impedance | 8 ohms nominal |
| Sensitivity | 85dB (2.83V/1m, measured, Audio Science Review) |
| Weight | 13 lbs / 5.9 kg each |
| Woofer Cabinet | ported, rear |
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
Wharfedale Super Denton: $1499 Crutchfield eBay
Pros: A 3-way design with a 1” soft dome tweeter, a 2” soft dome midrange offset to the side of a centered 6.5” woven Kevlar woofer - a more compact alternative to Wharfedale’s own Linton 85 with a similar overall character. Measured sensitivity around 86.6-87dB with on-axis linearity within about ±3dB. No cabinet or box resonances turned up in impedance testing, and there are no spike feet to install. Harmonic distortion looks good at both 86dB and 96dB, with about 20dB of usable dynamic range up to 96dB before compression starts to affect the midrange more noticeably near 102dB. Because bass rolls off starting around 60Hz, placing it closer to a wall (about 1-2 feet) than usual boosts low-end punch without the midbass bloat a deeper-extending speaker would get from the same placement. In the reviewer’s own comparison, its estimated in-room response actually measured more linear than the pricier Linton 85’s, despite being a bit less linear on-axis.
Cons: A mid-range scoop from about 200-800Hz and a separate upper-midrange scoop were both audible in direct ABX comparison against a reference-neutral speaker, giving aggressive-sounding material a more subdued character. A resonance around 660-700Hz shows up in measurement, though the reviewer couldn’t reliably hear it with real music in his own blind-ish A/B testing. The offset tweeter-and-midrange layout makes horizontal off-axis response noticeably asymmetric - response drops as much as 8dB more to one side than the other at wider angles - so the reviewer recommends aiming the speakers directly at the listener (not toed out, which loses upper treble) and suggests sidewall absorption to control uneven reflections. Must be listened to with the grille on - measurements are noticeably worse with it off (wider 2-4kHz dip, extra treble bump). Horizontal soundstage width felt a bit narrower than the reviewer personally prefers, likely related to the same offset driver layout. Multitone distortion gets high in the midrange at 96dB/1m, a concern mainly in larger rooms where you’d need to play louder.
Full Wharfedale Super Denton review and specifications →
| Bass Extension (-10dB) | 41Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 61Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 940Hz, 4.6kHz |
| Dimensions | 14.2"H x 9.7"W x 10.8"D (360 x 246 x 275 mm) |
| Drivers | 1" soft dome tweeter, 2" soft dome midrange, 6.5" woven Kevlar woofer |
| Frequency Response | 52Hz - 20kHz (±3dB, manufacturer specified); -6dB to 40Hz |
| Impedance | 6 ohms nominal, 3 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 86.6dB (measured by Erin's Audio Corner) |
| Weight | 20.3 lbs / 9.2 kg (20.2 lbs) each |
| Woofer Cabinet | ported |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Wharfedale Super Denton vs Klipsch RP-500M II
- Wharfedale Super Denton vs Wharfedale Diamond 12.1
- Wharfedale Super Denton vs Monitor Audio Silver 50 7G
- Wharfedale Super Denton vs Revel M105
- Wharfedale Super Denton vs KEF Q150
- Wharfedale Super Denton vs Wharfedale Diamond 220
- Wharfedale Super Denton vs Arendal 1961 Monitor
- Wharfedale Super Denton vs Polk Audio XT15
- See all 23 comparisons