Short answer: the Kali Audio IN-8 V2. It ranks #11 of 66 powered bookshelf speakers by sound quality at $499; the Genelec 8341A ranks #43 and costs $6590, so there is not much of a tradeoff to weigh.
What the Kali Audio IN-8 V2 offers: Three-way coaxial (coincident) driver in a front-ported cabinet, allowing near-wall placement without port noise issues; extensive dip switches handle boundary compensation, plus XLR/TRS/RCA inputs and a gain-matching volume knob. A built-in limiter makes it essentially impossible to push into mechanical distress - no cabinet buzzing, woofer bottoming, or audible failure even driven hard to 80-95dB in testing. Distortion stays below 1% THD at 86dB and under 3% at 96dB, largely thanks to that limiter. Frequency response and dynamic behavior stay essentially unchanged from 76dB up to 96dB/1m before the limiter engages around 96-102dB. Bass extends smoothly to about 50Hz. A clear step up in linearity over the original V1 version both on-axis and in estimated in-room response, and eliminates the hiss that drew complaints on the V1. Excellent soundstage depth, a benefit typical of coaxial designs, at $800/pair. Watch for: Notable forwardness/brashness in the 4-5kHz range when listened to on-axis, needing about 10° of toe-out (Kali’s own recommendation for the coaxial design) plus some EQ to fully resolve. A dip near the tweeter/voice-coil transition, likely a cancellation effect from the coincident driver’s geometry, is also improved by toeing off-axis. Bass rolls off below about 50Hz, so heavy low-bass material still needs a subwoofer. A minor resonance around 160Hz occasionally made low vocals sound a bit “hot,” though the reviewer rates it minor (about 2/10 in severity). Horizontal soundstage is narrower than non-coaxial alternatives, a typical trade-off of coincident driver designs. Vertical placement tolerance is fairly tight - usable to about ±10°, degrading past ±20°. Designed as a near/midfield monitor for roughly 1-3m listening distances, not intended as a home-theater speaker.
What the Genelec 8341A offers: CEA2034 spinorama shows an exceptionally flat on-axis response, within about +1.8dB/-2.2dB of the target curve, with excellent directivity control from the coaxial midrange/tweeter and dual 6.5” woofers. Tri-amplified design totals 550W across bass, mid, and treble sections. Watch for: The bass amplifier runs out of headroom well before the mid/treble sections, producing audible glitching/ticking distortion at higher volumes even at 1 meter - not well suited to larger rooms or higher playback levels as a result. No hard power switch, and it produces a loud static pop when AC power is cut. Very expensive at $6,590 per pair.
Buy the Kali Audio IN-8 V2. It ranks higher for sound quality than the Genelec 8341A and costs less, so there is no real case for the other one.
Specifications Side By Side
| Kali Audio IN-8 V2 | Genelec 8341A | |
|---|---|---|
| Price | $499.00 | $6590 |
| Ranked | #11 of 66 in Large Size Powered Bookshelf Speakers | #43 of 66 in Large Size Powered Bookshelf Speakers |
| Bass Extension (-10dB) | 36Hz (measured, Erin’s Audio Corner) | 40Hz (measured, Audio Science Review) |
| Bass Extension (-3dB) | 44Hz (measured, Erin’s Audio Corner) | 58Hz (measured, Audio Science Review) |
| Dimensions | 17.8"H x 10"W x 11.3"D (452.1 x 254 x 287 mm) | not published by manufacturer |
| Inputs | XLR, RCA | - |
| Weight | 22.9 lbs / 10.4 kg each | not published by manufacturer |
| Drivers | 8" (203mm) woofer | 2x 6.5" woofers, 3.5" midrange, 0.75" tweeter (coaxial mid/tweeter) |
| App | No | No |
| Bluetooth | No | - |
| EQ | Yes (Room adjustment) | Yes (Room adjustment) |
| DSP | No | No |
| Output Power | 140w Per Speaker | 550W total (250W bass, 150W mid, 150W treble) |
| Sensitivity | 89dB (measured at 0.3V/1m, Erin’s Audio Corner) | - |
| Frequency Response | - | 338Hz - 37kHz (-6dB) (Manufacturer specified) |
Related Speaker Comparisons
More useful head-to-heads from the same speaker class:
- Buchardt A500 vs JBL 4305P
- Buchardt A500 vs Focal Twin6 Be
- Buchardt A500 vs Buchardt A10
- Focal Alpha 65 EVO vs Genelec 8341A
- Edifier R2850DB vs Genelec 8341A
Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
Kali Audio IN-8 V2: $499.00 Amazon eBay
Pros: Three-way coaxial (coincident) driver in a front-ported cabinet, allowing near-wall placement without port noise issues; extensive dip switches handle boundary compensation, plus XLR/TRS/RCA inputs and a gain-matching volume knob. A built-in limiter makes it essentially impossible to push into mechanical distress - no cabinet buzzing, woofer bottoming, or audible failure even driven hard to 80-95dB in testing. Distortion stays below 1% THD at 86dB and under 3% at 96dB, largely thanks to that limiter. Frequency response and dynamic behavior stay essentially unchanged from 76dB up to 96dB/1m before the limiter engages around 96-102dB. Bass extends smoothly to about 50Hz. A clear step up in linearity over the original V1 version both on-axis and in estimated in-room response, and eliminates the hiss that drew complaints on the V1. Excellent soundstage depth, a benefit typical of coaxial designs, at $800/pair.
Cons: Notable forwardness/brashness in the 4-5kHz range when listened to on-axis, needing about 10° of toe-out (Kali’s own recommendation for the coaxial design) plus some EQ to fully resolve. A dip near the tweeter/voice-coil transition, likely a cancellation effect from the coincident driver’s geometry, is also improved by toeing off-axis. Bass rolls off below about 50Hz, so heavy low-bass material still needs a subwoofer. A minor resonance around 160Hz occasionally made low vocals sound a bit “hot,” though the reviewer rates it minor (about 2/10 in severity). Horizontal soundstage is narrower than non-coaxial alternatives, a typical trade-off of coincident driver designs. Vertical placement tolerance is fairly tight - usable to about ±10°, degrading past ±20°. Designed as a near/midfield monitor for roughly 1-3m listening distances, not intended as a home-theater speaker.
Full Kali Audio IN-8 V2 review and specifications →
| App | No |
|---|---|
| Bass Extension (-10dB) | 36Hz (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 44Hz (measured, Erin's Audio Corner) |
| Bluetooth | No |
| DSP | No |
| Dimensions | 17.8"H x 10"W x 11.3"D (452.1 x 254 x 287 mm) |
| Drivers | 8" (203mm) woofer |
| EQ | Yes (Room adjustment) |
| Inputs | XLR, RCA |
| Output Power | 140w Per Speaker |
| Sensitivity | 89dB (measured at 0.3V/1m, Erin's Audio Corner) |
| Weight | 22.9 lbs / 10.4 kg each |
- Links
- Reviews, Comparisons and Sound Samples
- Erin’s Audio Corner: Kali IN-8 Second Wave Masterful Music on a Budget More from Erin’s Audio Corner →
- Erin’s Audio Corner Website Kali Audio IN-8
- Erin’s Audio Corner: I Tested 250 Speakers So You Don’t Have To!
- Erin’s Audio Corner Measurements (spinorama.org)
- Reddit Search for Kali Audio IN-8 V2 Review
- Head-to-Head Comparisons
- Kali Audio IN-8 V2 vs APS Klasik 2020
- Kali Audio IN-8 V2 vs Genelec 8040B
- Kali Audio IN-8 V2 vs Neumann KH 310 A
- Kali Audio IN-8 V2 vs Genelec 8050B
- Kali Audio IN-8 V2 vs Neumann KH 150
- Kali Audio IN-8 V2 vs Yamaha HS8
- Kali Audio IN-8 V2 vs JBL 4305P
- Kali Audio IN-8 V2 vs Genelec 8351B
- See all 30 comparisons
Genelec 8341A: $6590 Bhphotovideo eBay
Pros: CEA2034 spinorama shows an exceptionally flat on-axis response, within about +1.8dB/-2.2dB of the target curve, with excellent directivity control from the coaxial midrange/tweeter and dual 6.5” woofers. Tri-amplified design totals 550W across bass, mid, and treble sections.
Cons: The bass amplifier runs out of headroom well before the mid/treble sections, producing audible glitching/ticking distortion at higher volumes even at 1 meter - not well suited to larger rooms or higher playback levels as a result. No hard power switch, and it produces a loud static pop when AC power is cut. Very expensive at $6,590 per pair.
Full Genelec 8341A review and specifications →
| App | No |
|---|---|
| Bass Extension (-10dB) | 40Hz (measured, Audio Science Review) |
| Bass Extension (-3dB) | 58Hz (measured, Audio Science Review) |
| DSP | No |
| Dimensions | not published by manufacturer |
| Drivers | 2x 6.5" woofers, 3.5" midrange, 0.75" tweeter (coaxial mid/tweeter) |
| EQ | Yes (Room adjustment) |
| Frequency Response | 338Hz - 37kHz (-6dB) (Manufacturer specified) |
| Output Power | 550W total (250W bass, 150W mid, 150W treble) |
| Weight | not published by manufacturer |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons