Short answer: the AsciLab F6Bs if sound quality matters most, the SVS Prime Bookshelf if price matters most. The AsciLab F6Bs ranks #20 of 130 bookshelf speakers at $799. The SVS Prime Bookshelf ranks #88 at $699, $100 cheaper.
What the AsciLab F6Bs offers: A slimmer, sealed, VESA 100 wall mountable variant of AsciLab’s F6B, trading the F6B’s passive radiator for a shallower 15.4cm deep cabinet that can go straight on a wall bracket. The sound power directivity index has the tightest standard deviation, 3.32, of anything in this batch of new additions, meaning off axis energy tracks the on axis response unusually consistently for a sealed 2-way this size, and on axis deviation measures a clean 0.25dB average. Watch for: AsciLab’s own site shows the F6Bs sold out, though it remains in stock through resellers like Audiophonics and Tested Audio. Bass extension is measured at 82.0Hz at -3dB, noticeably less than the passive radiator equipped F6B, and listening window smoothness measures only a moderate 0.39. The 4 ohm nominal impedance calls for a reasonably capable amplifier.
What the SVS Prime Bookshelf offers: Reasonable sensitivity for the price at about 87dB, and the 6.5” woofer sits in its own dedicated sealed sub-compartment inside the cabinet for cleaner midrange/bass separation. Overall response stays within about ±3dB from 80Hz-16kHz, which the reviewer calls reasonable for the price point. Wide, consistent horizontal radiation. Toeing the speakers 30 degrees off-axis smooths the in-room response noticeably if the on-axis tonal balance isn’t to your taste. Watch for: A scooped mid-range paired with a boosted upper mid-range creates an audibly uneven tonal balance, and there’s an additional dip in the treble around 4-5kHz that reads as slightly tinny relative to the recessed mid-range. Measured minimum impedance dips below 4 ohms (EPDR even lower), so an 8-ohm-only amplifier or AVR may struggle - a 4-ohm-stable amp or separate amplification is recommended. Bass extension is modest (F3 72Hz, F10 49Hz measured) - SVS clearly designed this to be paired with one of their subwoofers rather than to stand fully alone. Compared directly against its pricier sibling, the SVS Ultra Bookshelf, in the same review, the reviewer found the Ultra noticeably more tonally neutral.
Buy the AsciLab F6Bs if sound quality matters more than the price. Buy the SVS Prime Bookshelf if the price matters more than sound quality.
Looking for alternatives? See the complete Passive Home rankings.
Specifications Side By Side
| AsciLab F6Bs | SVS Prime Bookshelf | |
|---|---|---|
| Price | €799 per pair | $699.00 per pair |
| Ranked | #20 of 130 in Large Size Bookshelf Speakers | #88 of 130 in Large Size Bookshelf Speakers |
| Enclosure | sealed | - |
| Drivers | 1" aluminum dome tweeter with waveguide and phase plug, 6" fiber cone woofer | 6.5" polypropylene cone woofer with aluminum shorting ring (sealed sub-compartment), 1" aluminum dome tweeter |
| Dimensions | 14.5"H x 8"W x 6.1"D (368 x 203 x 154 mm) | - |
| Weight | 12.3 lbs (5.6 kg) each | 15.5 lbs (7.03 kg) each |
| Sensitivity | 85.2dB @ 2.83V/1m (measured, Audio Science Review) | 87dB (measured average, Erin's Audio Corner) |
| Impedance | 4 ohms nominal, 3.7 ohms minimum | 8 ohms nominal, 3.9 ohms minimum (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 82.0Hz (measured, Audio Science Review) | 72Hz (measured, Erin's Audio Corner) |
| Bass Extension (-10dB) | 50.1Hz (measured, Audio Science Review) | 49Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 1kHz | - |
| Mounting | VESA 100 wall mount compatible | - |
| Warranty | 2 years | - |
| Country | South Korea | - |
| Maximum SPL | 100dB full bandwidth, 102dB above 100Hz (manufacturer specified) | - |
| Spinorama Preference Score | 4.35 | 4.26 |
| Spinorama Preference Score with Perfect Sub | 7.01 | 6.88 |
| Frequency Response | - | 48Hz - 25kHz ±3dB (manufacturer specified) |
Related Speaker Comparisons
How AsciLab F6Bs compares with other leading options:
- AsciLab F6Bs vs Perlisten S4b
- AsciLab F6Bs vs KEF Reference 1 Meta
- AsciLab F6Bs vs GR-Research NX-Studio
- AsciLab C6B vs AsciLab F6Bs
- Audio First Cadentia 3 vs AsciLab F6Bs
Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
AsciLab F6Bs: €799 per pair Audiophonics eBay
Pros: A slimmer, sealed, VESA 100 wall mountable variant of AsciLab’s F6B, trading the F6B’s passive radiator for a shallower 15.4cm deep cabinet that can go straight on a wall bracket. The sound power directivity index has the tightest standard deviation, 3.32, of anything in this batch of new additions, meaning off axis energy tracks the on axis response unusually consistently for a sealed 2-way this size, and on axis deviation measures a clean 0.25dB average. Measured bass extension of 82.0Hz (-3dB), with a measured sensitivity of 85.2dB.
Cons: AsciLab’s own site shows the F6Bs sold out, though it remains in stock through resellers like Audiophonics and Tested Audio. Bass extension is measured at 82.0Hz at -3dB, noticeably less than the passive radiator equipped F6B, and listening window smoothness measures only a moderate 0.39. The 4 ohm nominal impedance calls for a reasonably capable amplifier.
Full AsciLab F6Bs review and specifications →
| Bass Extension (-10dB) | 50.1Hz (measured, Audio Science Review) |
|---|---|
| Bass Extension (-3dB) | 82.0Hz (measured, Audio Science Review) |
| Country | South Korea |
| Crossover Frequency | 1kHz |
| Dimensions | 14.5"H x 8"W x 6.1"D (368 x 203 x 154 mm) |
| Drivers | 1" aluminum dome tweeter with waveguide and phase plug, 6" fiber cone woofer |
| Enclosure | sealed |
| Impedance | 4 ohms nominal, 3.7 ohms minimum |
| Maximum SPL | 100dB full bandwidth, 102dB above 100Hz (manufacturer specified) |
| Mounting | VESA 100 wall mount compatible |
| Sensitivity | 85.2dB @ 2.83V/1m (measured, Audio Science Review) |
| Spinorama Preference Score | 4.35 |
| Spinorama Preference Score with Perfect Sub | 7.01 |
| Warranty | 2 years |
| Weight | 12.3 lbs (5.6 kg) each |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- AsciLab F6Bs vs Epos ES14N
- AsciLab F6Bs vs Arendal 1528 Monitor 8
- AsciLab F6Bs vs MoFi SourcePoint 8
- AsciLab F6Bs vs Ascend Acoustics CMT-340 SE2
- AsciLab F6Bs vs Wharfedale Super Linton
- AsciLab F6Bs vs Buchardt Audio E50
- AsciLab F6Bs vs KEF R3
- AsciLab F6Bs vs MoFi SourcePoint 10
- See all 45 comparisons
SVS Prime Bookshelf: $699.00 per pair Amazon eBay
Pros: Reasonable sensitivity for the price at about 87dB, and the 6.5” woofer sits in its own dedicated sealed sub-compartment inside the cabinet for cleaner midrange/bass separation. Overall response stays within about ±3dB from 80Hz-16kHz, which the reviewer calls reasonable for the price point. Wide, consistent horizontal radiation. Toeing the speakers 30 degrees off-axis smooths the in-room response noticeably if the on-axis tonal balance isn’t to your taste. Measured bass extension of 72Hz (-3dB), with a measured sensitivity of 87dB.
Cons: A scooped mid-range paired with a boosted upper mid-range creates an audibly uneven tonal balance, and there’s an additional dip in the treble around 4-5kHz that reads as slightly tinny relative to the recessed mid-range. Measured minimum impedance dips below 4 ohms (EPDR even lower), so an 8-ohm-only amplifier or AVR may struggle - a 4-ohm-stable amp or separate amplification is recommended. Bass extension is modest (F3 72Hz, F10 49Hz measured) - SVS clearly designed this to be paired with one of their subwoofers rather than to stand fully alone. Compared directly against its pricier sibling, the SVS Ultra Bookshelf, in the same review, the reviewer found the Ultra noticeably more tonally neutral.
Full SVS Prime Bookshelf review and specifications →
| Bass Extension (-10dB) | 49Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 72Hz (measured, Erin's Audio Corner) |
| Drivers | 6.5" polypropylene cone woofer with aluminum shorting ring (sealed sub-compartment), 1" aluminum dome tweeter |
| Frequency Response | 48Hz - 25kHz ±3dB (manufacturer specified) |
| Impedance | 8 ohms nominal, 3.9 ohms minimum (measured, Erin's Audio Corner) |
| Sensitivity | 87dB (measured average, Erin's Audio Corner) |
| Spinorama Preference Score | 4.26 |
| Spinorama Preference Score with Perfect Sub | 6.88 |
| Weight | 15.5 lbs (7.03 kg) each |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- SVS Prime Bookshelf vs KEF Q3 Meta
- SVS Prime Bookshelf vs ELAC Debut 2.0 B6.2
- SVS Prime Bookshelf vs Polk Monitor XT20
- SVS Prime Bookshelf vs Dynaudio Special Forty
- SVS Prime Bookshelf vs Sonus Faber Lumina II
- SVS Prime Bookshelf vs Infinity IL10
- SVS Prime Bookshelf vs XTZ Spirit 4
- SVS Prime Bookshelf vs Focal Aria 906
- See all 55 comparisons