Short answer: the AsciLab F6Bs. It ranks #20 of 130 bookshelf speakers by sound quality at $799; the Dynaudio Emit 20 ranks #75 and costs $1049, so there is little reason to consider the other one.
What the AsciLab F6Bs offers: A slimmer, sealed, VESA 100 wall mountable variant of AsciLab’s F6B, trading the F6B’s passive radiator for a shallower 15.4cm deep cabinet that can go straight on a wall bracket. The sound power directivity index has the tightest standard deviation, 3.32, of anything in this batch of new additions, meaning off axis energy tracks the on axis response unusually consistently for a sealed 2-way this size, and on axis deviation measures a clean 0.25dB average. Watch for: AsciLab’s own site shows the F6Bs sold out, though it remains in stock through resellers like Audiophonics and Tested Audio. Bass extension is measured at 82.0Hz at -3dB, noticeably less than the passive radiator equipped F6B, and listening window smoothness measures only a moderate 0.39. The 4 ohm nominal impedance calls for a reasonably capable amplifier.
What the Dynaudio Emit 20 offers: Two-way design with a 28mm Esotar soft dome tweeter (Hexis-damped) and an 18cm mid-woofer, using a first-order crossover on the tweeter and second-order on the woofer. Exceptional bass extension for a bookshelf speaker - reaches a clean, authoritative 40Hz in-room, rare enough that the reviewer says most listeners could skip a subwoofer for typical music. Very low distortion across the board, staying below 1% THD down to 40Hz at 86dB and below 3% even at 96dB - unusually clean bass performance where most two-way bookshelf speakers start rising in distortion around 80Hz. Wide, remarkably consistent horizontal directivity (about ±50-60°) that holds steady up to roughly 13kHz - rare for a speaker in this format, thanks to a beveled tweeter edge that acts as a mild waveguide. Excellent compression and dynamic-range linearity at the frequency extremes, actually showing slight bass enhancement rather than the sharp low-end compression common in similarly-sized bookshelf speakers. Watch for: A resonance around 600-800Hz gives snares and similar percussion a muffled, flat quality lacking impact - confirmed as originating in the woofer itself (isolated via measurements of the raw driver out of the cabinet), and attempts at constrained-layer damping didn’t resolve it. A peak around 4kHz adds a sharp, edgy quality to some male vocals. A roughly 5dB boost above 10kHz gives cymbals and hi-hats excess shimmer that can sound unnatural, especially pointed directly on-axis. Vertical dispersion shows two separate crossover-related notches (above and below the tweeter reference line around 5kHz) rather than the usual single one, a direct consequence of the shallow crossover slopes used on both drivers. Multitone distortion is elevated in the midrange, possibly due to the woofer’s magnet structure lacking a shorting ring. Best aimed slightly off-axis (about 10-15° of toe-out) to tame the excess high-frequency shimmer, rather than pointed straight at the listener.
Buy the AsciLab F6Bs. It ranks higher for sound quality than the Dynaudio Emit 20 and costs less, so there is no real case for the other one.
Want more options? Browse the full Passive Home rankings.
Specifications Side By Side
| AsciLab F6Bs | Dynaudio Emit 20 | |
|---|---|---|
| Price | €799 per pair | $1,049.00 per pair |
| Ranked | #20 of 130 in Large Size Bookshelf Speakers | #75 of 130 in Large Size Bookshelf Speakers |
| Enclosure | sealed | - |
| Drivers | 1" aluminum dome tweeter with waveguide and phase plug, 6" fiber cone woofer | 7.1" Magnesium Silicate Polymer woofer, 1.1" Cerotar soft dome with Hexis tweeter |
| Dimensions | 14.5"H x 8"W x 6.1"D (368 x 203 x 154 mm) | 14.6"H x 8.1"W x 12.3"D (370.0 x 205.0 x 312.0 mm) |
| Weight | 12.3 lbs (5.6 kg) each | 12.8 lbs (5.8 kg) |
| Sensitivity | 85.2dB @ 2.83V/1m (measured, Audio Science Review) | 83.5dB (measured, Erin's Audio Corner; 86dB manufacturer specified) |
| Impedance | 4 ohms nominal, 3.7 ohms minimum | 6 ohms nominal (5.5 ohms minimum above 80Hz, measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 82.0Hz (measured, Audio Science Review) | 54Hz (measured, Erin's Audio Corner) |
| Bass Extension (-10dB) | 50.1Hz (measured, Audio Science Review) | 33Hz (measured, Erin's Audio Corner) |
| Crossover Frequency | 1kHz | - |
| Mounting | VESA 100 wall mount compatible | - |
| Warranty | 2 years | - |
| Country | South Korea | - |
| Maximum SPL | 100dB full bandwidth, 102dB above 100Hz (manufacturer specified) | - |
| Spinorama Preference Score | 4.35 | 3.35 |
| Spinorama Preference Score with Perfect Sub | 7.01 | 5.05 |
| Woofer Cabinet | - | ported, rear |
Related Speaker Comparisons
More top alternatives to AsciLab F6Bs:
- AsciLab F6Bs vs Perlisten S4b
- AsciLab F6Bs vs KEF Reference 1 Meta
- AsciLab F6Bs vs GR-Research NX-Studio
- AsciLab C6B vs AsciLab F6Bs
- Audio First Cadentia 3 vs AsciLab F6Bs
Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
AsciLab F6Bs: €799 per pair Audiophonics eBay
Pros: A slimmer, sealed, VESA 100 wall mountable variant of AsciLab’s F6B, trading the F6B’s passive radiator for a shallower 15.4cm deep cabinet that can go straight on a wall bracket. The sound power directivity index has the tightest standard deviation, 3.32, of anything in this batch of new additions, meaning off axis energy tracks the on axis response unusually consistently for a sealed 2-way this size, and on axis deviation measures a clean 0.25dB average. Measured bass extension of 82.0Hz (-3dB), with a measured sensitivity of 85.2dB.
Cons: AsciLab’s own site shows the F6Bs sold out, though it remains in stock through resellers like Audiophonics and Tested Audio. Bass extension is measured at 82.0Hz at -3dB, noticeably less than the passive radiator equipped F6B, and listening window smoothness measures only a moderate 0.39. The 4 ohm nominal impedance calls for a reasonably capable amplifier.
Full AsciLab F6Bs review and specifications →
| Bass Extension (-10dB) | 50.1Hz (measured, Audio Science Review) |
|---|---|
| Bass Extension (-3dB) | 82.0Hz (measured, Audio Science Review) |
| Country | South Korea |
| Crossover Frequency | 1kHz |
| Dimensions | 14.5"H x 8"W x 6.1"D (368 x 203 x 154 mm) |
| Drivers | 1" aluminum dome tweeter with waveguide and phase plug, 6" fiber cone woofer |
| Enclosure | sealed |
| Impedance | 4 ohms nominal, 3.7 ohms minimum |
| Maximum SPL | 100dB full bandwidth, 102dB above 100Hz (manufacturer specified) |
| Mounting | VESA 100 wall mount compatible |
| Sensitivity | 85.2dB @ 2.83V/1m (measured, Audio Science Review) |
| Spinorama Preference Score | 4.35 |
| Spinorama Preference Score with Perfect Sub | 7.01 |
| Warranty | 2 years |
| Weight | 12.3 lbs (5.6 kg) each |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- AsciLab F6Bs vs Epos ES14N
- AsciLab F6Bs vs Arendal 1528 Monitor 8
- AsciLab F6Bs vs MoFi SourcePoint 8
- AsciLab F6Bs vs Ascend Acoustics CMT-340 SE2
- AsciLab F6Bs vs Wharfedale Super Linton
- AsciLab F6Bs vs Buchardt Audio E50
- AsciLab F6Bs vs KEF R3
- AsciLab F6Bs vs MoFi SourcePoint 10
- See all 45 comparisons
Dynaudio Emit 20: $1,049.00 per pair Amazon eBay
Pros: Two-way design with a 28mm Esotar soft dome tweeter (Hexis-damped) and an 18cm mid-woofer, using a first-order crossover on the tweeter and second-order on the woofer. Exceptional bass extension for a bookshelf speaker - reaches a clean, authoritative 40Hz in-room, rare enough that the reviewer says most listeners could skip a subwoofer for typical music. Very low distortion across the board, staying below 1% THD down to 40Hz at 86dB and below 3% even at 96dB - unusually clean bass performance where most two-way bookshelf speakers start rising in distortion around 80Hz. Wide, remarkably consistent horizontal directivity (about ±50-60°) that holds steady up to roughly 13kHz - rare for a speaker in this format, thanks to a beveled tweeter edge that acts as a mild waveguide. Excellent compression and dynamic-range linearity at the frequency extremes, actually showing slight bass enhancement rather than the sharp low-end compression common in similarly-sized bookshelf speakers. Measured bass extension of 54Hz (-3dB), with a measured sensitivity of 83.5dB.
Cons: A resonance around 600-800Hz gives snares and similar percussion a muffled, flat quality lacking impact - confirmed as originating in the woofer itself (isolated via measurements of the raw driver out of the cabinet), and attempts at constrained-layer damping didn’t resolve it. A peak around 4kHz adds a sharp, edgy quality to some male vocals. A roughly 5dB boost above 10kHz gives cymbals and hi-hats excess shimmer that can sound unnatural, especially pointed directly on-axis. Vertical dispersion shows two separate crossover-related notches (above and below the tweeter reference line around 5kHz) rather than the usual single one, a direct consequence of the shallow crossover slopes used on both drivers. Multitone distortion is elevated in the midrange, possibly due to the woofer’s magnet structure lacking a shorting ring. Best aimed slightly off-axis (about 10-15° of toe-out) to tame the excess high-frequency shimmer, rather than pointed straight at the listener.
Full Dynaudio Emit 20 review and specifications →
| Bass Extension (-10dB) | 33Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 54Hz (measured, Erin's Audio Corner) |
| Dimensions | 14.6"H x 8.1"W x 12.3"D (370.0 x 205.0 x 312.0 mm) |
| Drivers | 7.1" Magnesium Silicate Polymer woofer, 1.1" Cerotar soft dome with Hexis tweeter |
| Impedance | 6 ohms nominal (5.5 ohms minimum above 80Hz, measured, Erin's Audio Corner) |
| Sensitivity | 83.5dB (measured, Erin's Audio Corner; 86dB manufacturer specified) |
| Spinorama Preference Score | 3.35 |
| Spinorama Preference Score with Perfect Sub | 5.05 |
| Weight | 12.8 lbs (5.8 kg) |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Dynaudio Emit 20 vs Klipsch RP-600M II
- Dynaudio Emit 20 vs Philharmonic BMR Monitor
- Dynaudio Emit 20 vs JBL Studio 630
- Dynaudio Emit 20 vs Behringer B2030P
- Dynaudio Emit 20 vs Mission LX-3 MKII
- Dynaudio Emit 20 vs Polk Signature Elite ES20
- Dynaudio Emit 20 vs GR-Research X-LS Encore
- Dynaudio Emit 20 vs Infinity IL10
- See all 63 comparisons