Short answer: a tie on sound quality. Both are rated 3.9/5 (#275 and #278 of 450 in-ear headphones), so choose on features and fit.
What the 7Hz x Crinacle Zero 2 does well: Crinacle’s measurement gives it a preference score of 73, and an average deviation of just 2 dB from the Harman target is unusually even for a budget single dynamic driver. The catch: Hobbyist measurements show the presence region about 3 dB shy of target with a 4.7 dB dip near 5.9 kHz, which can make guitars and vocal consonants sound a little veiled.
The case for the DUNU Titan S: Crinacle’s measurement gives it a preference score of 73, and across 34 hobbyist measurements on squig.link the bass, low mids and upper mids all land within half a decibel of the Harman target. The tradeoff: Hobbyist measurements put sub-bass about 3.2 dB below target, so the deepest synth and cinematic bass hits carry less rumble than the Harman curve calls for.
Buy the 7Hz x Crinacle Zero 2 or the DUNU Titan S on features: they are rated the same for sound quality at close to the same price.
Want more options? Browse the full Headphones rankings.
Specifications Side By Side
| 7Hz x Crinacle Zero 2 | DUNU Titan S | |
|---|---|---|
| Price | $24.99 | - |
| Ranked | #275 of 450 in In-Ear Headphones | #278 of 450 in In-Ear Headphones |
| Form Factor | In-ear | In-ear |
| Harman Preference Score | 73 (measured by crinacle, via AutoEQ) | 73 (measured by crinacle, via AutoEQ) |
| Deviation From Target | 1.99 dB standard deviation | 2.29 dB standard deviation |
| Tonal Tilt | -0.71 (negative is warmer, positive brighter) | +0.29 (negative is warmer, positive brighter) |
| Connection | Wired | Wired |
| Driver Type | Dynamic | Dynamic |
| Drivers | 1 x 10mm dynamic | 1 x 11mm dynamic |
| Impedance | 32 ohms | 32 ohms |
| Sensitivity | 108 dB SPL/V | 110 dB |
| Frequency Response | 10Hz - 20kHz (Manufacturer specified) | 5Hz - 40kHz (Manufacturer specified) |
| Back | Closed | Closed |
| Sub-bass Extension | Within 6 dB of target down to 20 Hz (+1.1 dB at 30 Hz) | Within 6 dB of target down to 20 Hz (-3.4 dB at 30 Hz) |
Related Headphone Comparisons
More top alternatives to 7Hz x Crinacle Zero 2:
- KZ ZSN Pro X vs 7Hz x Crinacle Zero 2
- Letshuoer D02 vs 7Hz x Crinacle Zero 2
- 7Hz x Crinacle Zero 2 vs KZ ZSN Pro
- 7Hz x Crinacle Zero 2 vs CCA CRA
- 7Hz x Crinacle Zero 2 vs Kiwi Ears Orchestra
Prices on this page were last checked October 11, 2026 at 4:59 PM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Headphones In Full
7Hz x Crinacle Zero 2: $24.99 Amazon AliExpress eBay
Older model: the 7Hz Salnotes Zero (ranked higher, rated 4.8/5). See every 7Hz Zero generation.
Pros: Crinacle’s measurement gives it a preference score of 73, and an average deviation of just 2 dB from the Harman target is unusually even for a budget single dynamic driver. Across four hobbyist measurements on squig.link, bass sits about 1.8 dB above target and sub-bass reaches flat to 20 Hz, so kick drums and synth lines have a gentle, full weight without swamping vocals. The mildly warm balance suits listeners who like a relaxed, bassy tilt over a bright one.
Cons: Hobbyist measurements show the presence region about 3 dB shy of target with a 4.7 dB dip near 5.9 kHz, which can make guitars and vocal consonants sound a little veiled. A 4.2 dB lift near 11.9 kHz adds some sparkle on top that can draw attention to cymbals. The KZ ZSN Pro X rates slightly higher at a similar price.
Full 7Hz x Crinacle Zero 2 review and specifications →
| Released | Nov 2023 (2 years ago) |
|---|---|
| Back | Closed |
| Connection | Wired |
| Deviation From Target | 1.99 dB standard deviation |
| Driver Type | Dynamic |
| Drivers | 1 x 10mm dynamic |
| Form Factor | In-ear |
| Frequency Response | 10Hz - 20kHz (Manufacturer specified) |
| Harman Preference Score | 73 (measured by crinacle, via AutoEQ) |
| Impedance | 32 ohms |
| Sensitivity | 108 dB SPL/V |
| Sub-bass Extension | Within 6 dB of target down to 20 Hz (+1.1 dB at 30 Hz) |
| Tonal Tilt | -0.71 (negative is warmer, positive brighter) |
EQ preset to match the Harman target
Set a preamp of -4.4 dB, then add these filters in any parametric equalizer (Wavelet, Equalizer APO, Peace, or a player with parametric EQ). Calculated by AutoEQ from its measured frequency response.
| Filter | Frequency | Gain | Q |
|---|---|---|---|
| Low shelf | 105 Hz | -1.1 dB | 0.70 |
| Peak | 6,290 Hz | +4.3 dB | 0.72 |
| Peak | 182 Hz | -2.3 dB | 1.03 |
| Peak | 1,916 Hz | -1.7 dB | 0.50 |
| Peak | 855 Hz | +1.8 dB | 1.59 |
| High shelf | 10,000 Hz | +0.9 dB | 0.70 |
| Peak | 67 Hz | +0.4 dB | 2.53 |
| Peak | 7,224 Hz | -1.2 dB | 5.84 |
| Peak | 5,811 Hz | +0.8 dB | 5.07 |
| Peak | 3,871 Hz | -0.3 dB | 2.41 |
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
DUNU Titan S AliExpress eBay
Pros: Crinacle’s measurement gives it a preference score of 73, and across 34 hobbyist measurements on squig.link the bass, low mids and upper mids all land within half a decibel of the Harman target. That keeps vocals, piano and guitars sounding natural rather than pushed forward or recessed. With a 32 ohm load and a 110 dB sensitivity rating, it plays at comfortable volume straight from a phone.
Cons: Hobbyist measurements put sub-bass about 3.2 dB below target, so the deepest synth and cinematic bass hits carry less rumble than the Harman curve calls for. A 4.9 dB dip near 6.1 kHz followed by a 4.1 dB peak near 11.9 kHz gives the treble an uneven texture, softening some detail while adding a touch of glare up top.
Full DUNU Titan S review and specifications →
| Released | Dec 2021 (4 years ago) |
|---|---|
| Back | Closed |
| Connection | Wired |
| Deviation From Target | 2.29 dB standard deviation |
| Driver Type | Dynamic |
| Drivers | 1 x 11mm dynamic |
| Form Factor | In-ear |
| Frequency Response | 5Hz - 40kHz (Manufacturer specified) |
| Harman Preference Score | 73 (measured by crinacle, via AutoEQ) |
| Impedance | 32 ohms |
| Sensitivity | 110 dB |
| Sub-bass Extension | Within 6 dB of target down to 20 Hz (-3.4 dB at 30 Hz) |
| Tonal Tilt | +0.29 (negative is warmer, positive brighter) |
EQ preset to match the Harman target
Set a preamp of -5.2 dB, then add these filters in any parametric equalizer (Wavelet, Equalizer APO, Peace, or a player with parametric EQ). Calculated by AutoEQ from its measured frequency response.
| Filter | Frequency | Gain | Q |
|---|---|---|---|
| Low shelf | 105 Hz | +10.1 dB | 0.70 |
| Peak | 5,993 Hz | +13.5 dB | 0.87 |
| Peak | 4,479 Hz | -9.3 dB | 0.51 |
| Peak | 40 Hz | -7.2 dB | 0.34 |
| Peak | 762 Hz | +2.2 dB | 1.04 |
| High shelf | 10,000 Hz | -5.4 dB | 0.70 |
| Peak | 9,592 Hz | +2.8 dB | 2.45 |
| Peak | 1,411 Hz | -0.8 dB | 2.84 |
| Peak | 2,335 Hz | +0.3 dB | 1.89 |
| Peak | 1,030 Hz | +0.5 dB | 3.30 |
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons