Short answer: the Radiant Acoustics Clarity 6.2 for better sound quality, the KEF Q3 Meta for the lower price. The Radiant Acoustics Clarity 6.2 ranks #27 of 130 bookshelf speakers at $4500. The KEF Q3 Meta ranks #89 at $899.99, $3600.01 cheaper.
What the KEF Q3 Meta offers: Coaxial two-way design (1” vented aluminum dome tweeter with Meta absorber embedded in a 6.5” aluminum cone mid/bass driver) delivering unusually wide dispersion both horizontally and vertically (about ±60° each) - wider than typical KEF models, which usually run closer to ±50° horizontal and ±15-20° vertical for non-coaxial designs. A deliberate ~2dB bump around 120Hz gives a satisfying sense of kick-drum impact, a voicing choice the reviewer personally favors even though it’s not strictly accurate. Extended bass-shelf tuning allows placement close to a rear wall (about 1 foot) without sounding boomy. Good directivity overall means it takes well to EQ correction if desired. Cabinet resonances around 350-370Hz and 600Hz look concerning in impedance measurements, but blind ABX testing (24 trials) after adding damping material couldn’t reliably distinguish the treated cabinet from the untreated one - these particular resonances appear to fall below the threshold of audibility. Sturdier build than previous KEF Q-series models. Watch for: Not well suited to high-output use: compression and strain in the 1-2kHz region emerge above about 90dB at 10 feet, so a high-output home theater setup isn’t the best application. A slight loss of attack and clarity around 1-2kHz was noticeable both subjectively and in measurements. F3 of 52Hz with a fairly quick rolloff below 50Hz means a subwoofer is still recommended for real bass extension, even for moderate-volume home theater use. Sealed configuration (using the included port bungs) pushes the bass rolloff up into the 100Hz+ region - the reviewer recommends leaving it in ported mode instead. Sounds best pointed directly at the listener; toeing it out 30° rolls off the top end without a meaningful soundstage benefit. Compression testing shows real breakdown at 102dB/1m, with the woofer losing excursion control - confirms the practical output ceiling. An unexplained -5dB dip appears in on-axis measurements that the reviewer couldn’t attribute to a specific cause.
What the Radiant Acoustics Clarity 6.2 offers: Custom AMT (Air Motion Transformer) tweeter paired with a 6.5” Purifi Eikona midrange and dual Purifi passive radiators in a passive-radiator enclosure, crossed over at 2.4kHz. Rigid cabinet construction (21mm MDF with a 15mm aluminum front baffle, extensive internal bracing) helps keep resonance in check. A deliberately rising on-axis response paired with narrowing directivity above about 2kHz yields a genuinely linear, non-fatiguing in-room sound rather than the “fake detail” of speakers with a straight treble boost. Excellent pair matching between units (within about 1dB), contributing to precise, well-focused imaging that clearly separated fine details in test tracks. In-room bass extension reaches a solid 40Hz with real kick-drum authority, not just sub-bass rumble. Class-leading dynamic range and compression performance - among the best the reviewer has measured at this price point. Watch for: Needs a fairly specific setup to sound its best: about 15-20° of toe-out (per the manufacturer’s own recommendation) and roughly 2 feet from the rear wall; pointed straight on-axis, the treble reads as noticeably elevated. Low impedance (2.1-ohm minimum, about 1-ohm minimum EPDR) demands an amplifier genuinely comfortable with 4-ohm-and-below loads. Soundstage width narrows above about 5kHz, even though the AMT tweeter itself is capable of wider dispersion. An unexplained resonance appears in harmonic distortion measurements on both units tested (though not on the reviewer’s reference speaker) - possibly a basket resonance, and not something the reviewer could hear. A minor bump around 500Hz in the estimated in-room response could add a touch of boxiness for some listeners, though the reviewer didn’t personally notice it. F3 of 55Hz and F10 of 32Hz mean a subwoofer is still needed for home-theater rumble or bass-heavy genres like rap.
Buy the KEF Q3 Meta when the price outweighs sound quality for you, and the Radiant Acoustics Clarity 6.2 when sound quality outweighs the price instead.
Looking for alternatives? See the complete Passive Home rankings.
Specifications Side By Side
| KEF Q3 Meta | Radiant Acoustics Clarity 6.2 | |
|---|---|---|
| Price | $899.99 per pair | $4500 per pair |
| Ranked | #89 of 130 in Large Size Bookshelf Speakers | #27 of 130 in Large Size Bookshelf Speakers |
| Bass Extension (-10dB) | 37Hz (measured, Erin's Audio Corner) | 32Hz (measured, Erin's Audio Corner) |
| Bass Extension (-3dB) | 52Hz (measured, Erin's Audio Corner) | 55Hz (measured, Erin's Audio Corner) |
| Impedance | 4 ohms nominal, 3.7 ohms minimum (measured above 80Hz, Erin's Audio Corner) | 4 ohms nominal (2.1 ohms minimum above 80Hz, measured, Erin's Audio Corner) |
| Sensitivity | 84.5dB (measured average 300Hz-3kHz @ 2.83V/1m, Erin's Audio Corner; 87dB manufacturer specified) | 84.3dB (measured, Erin's Audio Corner) |
| Drivers | 165 mm (6.5 in.) aluminium cone woofer, 25 mm (1 in.) vented aluminium dome with MAT tweeter | 6.5" PURIFI USHINDI woofer, Custom AMT (Air Motion Transformer) tweeter |
| Woofer Cabinet | ported, rear | passive radiator |
| Weight | 15.9 lbs (7.2 kg) | 23.8 lbs (10.8 kg) each |
| Dimensions | 14.1"H x 8.3"W x 12"D (357.0 x 210.0 x 305.0 mm) | 14.3"H x 8.7"W x 10.5"D (363.2 x 221 x 266.7 mm) |
| Spinorama Preference Score | 3.75 | 5.13 |
| Spinorama Preference Score with Perfect Sub | 5.59 | 6.90 |
Related Speaker Comparisons
More worthwhile head-to-heads for Radiant Acoustics Clarity 6.2:
- Radiant Acoustics Clarity 6.2 vs Perlisten S4b
- KEF Reference 1 Meta vs Radiant Acoustics Clarity 6.2
- Radiant Acoustics Clarity 6.2 vs GR-Research NX-Studio
- AsciLab C6B vs Radiant Acoustics Clarity 6.2
- Audio First Cadentia 3 vs Radiant Acoustics Clarity 6.2
Prices on this page were last checked September 16, 2026 at 12:41 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.
As an eBay Partner, we may be compensated if you make a purchase.
The Two Speakers In Full
KEF Q3 Meta: $899.99 per pair Amazon Crutchfield eBay
Pros: Coaxial two-way design (1” vented aluminum dome tweeter with Meta absorber embedded in a 6.5” aluminum cone mid/bass driver) delivering unusually wide dispersion both horizontally and vertically (about ±60° each) - wider than typical KEF models, which usually run closer to ±50° horizontal and ±15-20° vertical for non-coaxial designs. A deliberate ~2dB bump around 120Hz gives a satisfying sense of kick-drum impact, a voicing choice the reviewer personally favors even though it’s not strictly accurate. Extended bass-shelf tuning allows placement close to a rear wall (about 1 foot) without sounding boomy. Good directivity overall means it takes well to EQ correction if desired. Cabinet resonances around 350-370Hz and 600Hz look concerning in impedance measurements, but blind ABX testing (24 trials) after adding damping material couldn’t reliably distinguish the treated cabinet from the untreated one - these particular resonances appear to fall below the threshold of audibility. Sturdier build than previous KEF Q-series models. Measured bass extension of 52Hz (-3dB), with a measured sensitivity of 84.5dB.
Cons: Not well suited to high-output use: compression and strain in the 1-2kHz region emerge above about 90dB at 10 feet, so a high-output home theater setup isn’t the best application. A slight loss of attack and clarity around 1-2kHz was noticeable both subjectively and in measurements. F3 of 52Hz with a fairly quick rolloff below 50Hz means a subwoofer is still recommended for real bass extension, even for moderate-volume home theater use. Sealed configuration (using the included port bungs) pushes the bass rolloff up into the 100Hz+ region - the reviewer recommends leaving it in ported mode instead. Sounds best pointed directly at the listener; toeing it out 30° rolls off the top end without a meaningful soundstage benefit. Compression testing shows real breakdown at 102dB/1m, with the woofer losing excursion control - confirms the practical output ceiling. An unexplained -5dB dip appears in on-axis measurements that the reviewer couldn’t attribute to a specific cause.
Full KEF Q3 Meta review and specifications →
| Bass Extension (-10dB) | 37Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 52Hz (measured, Erin's Audio Corner) |
| Dimensions | 14.1"H x 8.3"W x 12"D (357.0 x 210.0 x 305.0 mm) |
| Drivers | 165 mm (6.5 in.) aluminium cone woofer, 25 mm (1 in.) vented aluminium dome with MAT tweeter |
| Impedance | 4 ohms nominal, 3.7 ohms minimum (measured above 80Hz, Erin's Audio Corner) |
| Sensitivity | 84.5dB (measured average 300Hz-3kHz @ 2.83V/1m, Erin's Audio Corner; 87dB manufacturer specified) |
| Spinorama Preference Score | 3.75 |
| Spinorama Preference Score with Perfect Sub | 5.59 |
| Weight | 15.9 lbs (7.2 kg) |
| Woofer Cabinet | ported, rear |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
Radiant Acoustics Clarity 6.2: $4500 per pair Radiantacoustics eBay
Pros: Custom AMT (Air Motion Transformer) tweeter paired with a 6.5” Purifi Eikona midrange and dual Purifi passive radiators in a passive-radiator enclosure, crossed over at 2.4kHz. Rigid cabinet construction (21mm MDF with a 15mm aluminum front baffle, extensive internal bracing) helps keep resonance in check. A deliberately rising on-axis response paired with narrowing directivity above about 2kHz yields a genuinely linear, non-fatiguing in-room sound rather than the “fake detail” of speakers with a straight treble boost. Excellent pair matching between units (within about 1dB), contributing to precise, well-focused imaging that clearly separated fine details in test tracks. In-room bass extension reaches a solid 40Hz with real kick-drum authority, not just sub-bass rumble. Class-leading dynamic range and compression performance - among the best the reviewer has measured at this price point. Measured bass extension of 55Hz (-3dB), with a measured sensitivity of 84.3dB.
Cons: Needs a fairly specific setup to sound its best: about 15-20° of toe-out (per the manufacturer’s own recommendation) and roughly 2 feet from the rear wall; pointed straight on-axis, the treble reads as noticeably elevated. Low impedance (2.1-ohm minimum, about 1-ohm minimum EPDR) demands an amplifier genuinely comfortable with 4-ohm-and-below loads. Soundstage width narrows above about 5kHz, even though the AMT tweeter itself is capable of wider dispersion. An unexplained resonance appears in harmonic distortion measurements on both units tested (though not on the reviewer’s reference speaker) - possibly a basket resonance, and not something the reviewer could hear. A minor bump around 500Hz in the estimated in-room response could add a touch of boxiness for some listeners, though the reviewer didn’t personally notice it. F3 of 55Hz and F10 of 32Hz mean a subwoofer is still needed for home-theater rumble or bass-heavy genres like rap.
Full Radiant Acoustics Clarity 6.2 review and specifications →
| Bass Extension (-10dB) | 32Hz (measured, Erin's Audio Corner) |
|---|---|
| Bass Extension (-3dB) | 55Hz (measured, Erin's Audio Corner) |
| Dimensions | 14.3"H x 8.7"W x 10.5"D (363.2 x 221 x 266.7 mm) |
| Drivers | 6.5" PURIFI USHINDI woofer, Custom AMT (Air Motion Transformer) tweeter |
| Impedance | 4 ohms nominal (2.1 ohms minimum above 80Hz, measured, Erin's Audio Corner) |
| Sensitivity | 84.3dB (measured, Erin's Audio Corner) |
| Spinorama Preference Score | 5.13 |
| Spinorama Preference Score with Perfect Sub | 6.90 |
| Weight | 23.8 lbs (10.8 kg) each |
| Woofer Cabinet | passive radiator |
- Links
- Reviews, Comparisons and Sound Samples
- Head-to-Head Comparisons
- Radiant Acoustics Clarity 6.2 vs MoFi SourcePoint 10
- Radiant Acoustics Clarity 6.2 vs Dynaudio Heritage Special
- Radiant Acoustics Clarity 6.2 vs Wharfedale Super Linton
- Radiant Acoustics Clarity 6.2 vs Ascend Acoustics CMT-340 SE2
- Radiant Acoustics Clarity 6.2 vs Wharfedale Linton 85
- Radiant Acoustics Clarity 6.2 vs Arendal 1528 Monitor 8
- Radiant Acoustics Clarity 6.2 vs Ascend Acoustics Sierra-LX
- Radiant Acoustics Clarity 6.2 vs Revel M126Be
- See all 45 comparisons