Dynaudio Emit 20 vs Wharfedale Diamond 9.1

Last updated: August 25, 2026

Short answer: the Dynaudio Emit 20. It ranks #76 of 131 bookshelf speakers by sound quality; the Wharfedale Diamond 9.1 ranks #109.

What the Dynaudio Emit 20 offers: Two-way design with a 28mm Esotar soft dome tweeter (Hexis-damped) and an 18cm mid-woofer, using a first-order crossover on the tweeter and second-order on the woofer. Exceptional bass extension for a bookshelf speaker - reaches a clean, authoritative 40Hz in-room, rare enough that the reviewer says most listeners could skip a subwoofer for typical music. Very low distortion across the board, staying below 1% THD down to 40Hz at 86dB and below 3% even at 96dB - unusually clean bass performance where most two-way bookshelf speakers start rising in distortion around 80Hz. Wide, remarkably consistent horizontal directivity (about ±50-60°) that holds steady up to roughly 13kHz - rare for a speaker in this format, thanks to a beveled tweeter edge that acts as a mild waveguide. Excellent compression and dynamic-range linearity at the frequency extremes, actually showing slight bass enhancement rather than the sharp low-end compression common in similarly-sized bookshelf speakers. Watch for: A resonance around 600-800Hz gives snares and similar percussion a muffled, flat quality lacking impact - confirmed as originating in the woofer itself (isolated via measurements of the raw driver out of the cabinet), and attempts at constrained-layer damping didn’t resolve it. A peak around 4kHz adds a sharp, edgy quality to some male vocals. A roughly 5dB boost above 10kHz gives cymbals and hi-hats excess shimmer that can sound unnatural, especially pointed directly on-axis. Vertical dispersion shows two separate crossover-related notches (above and below the tweeter reference line around 5kHz) rather than the usual single one, a direct consequence of the shallow crossover slopes used on both drivers. Multitone distortion is elevated in the midrange, possibly due to the woofer’s magnet structure lacking a shorting ring. Best aimed slightly off-axis (about 10-15° of toe-out) to tame the excess high-frequency shimmer, rather than pointed straight at the listener.

What the Wharfedale Diamond 9.1 offers: The first design was a pretty good sounding speaker, the speaker was then outsourced to China and lost 1.5kg and was made with cheap parts and sounds much worse. Slightly rolled off in the treble by about 3dB Watch for: All current new ones sold today are the crap version.

Buy the Dynaudio Emit 20 if sound quality matters more than the price. Buy the Wharfedale Diamond 9.1 if the price matters more than sound quality.

If sound quality matters at all to you, skip the Wharfedale Diamond 9.1. It ranks near the bottom of the 131 bookshelf speakers, so look higher up the list instead.

Dynaudio Emit 20 vs Wharfedale Diamond 9.1

Specifications Side By Side

Dynaudio Emit 20 Wharfedale Diamond 9.1
Price$1,049.00Discontinued
Ranked#76 of 131 in Large Size Bookshelf Speakers#109 of 131 in Large Size Bookshelf Speakers
Bass Extension (-10dB)33Hz (measured, Erin’s Audio Corner)-
Bass Extension (-3dB)54Hz (measured, Erin’s Audio Corner)-
Drivers7.1" Magnesium Silicate Polymer woofer, 1.1" Cerotar soft dome with Hexis tweeter6.5" Kevlar cone woofer, 1" soft dome tweeter
Weight12.8 lbs / 5.8 kg12.1 lbs / 5.5 kg (good version), 9.9 lbs / 4.5 kg (bad version) each
Sensitivity83.5dB (measured, Erin’s Audio Corner; 86dB manufacturer specified)87dB
Impedance6 ohms nominal (5.5 ohms minimum above 80Hz, measured, Erin’s Audio Corner)6 ohms
Dimensions14.6"H x 8.1"W x 12.3"D (370.0 x 205.0 x 312.0 mm)11.7"H x 7.6"W x 10.9"D (296.0 x 194.0 x 278.0 mm)
Woofer Cabinetported, rearported
Discontinued-Yes

More useful head-to-heads from the same speaker class:

Prices on this page were last checked August 25, 2026 at 6:19 AM UTC. Product prices and availability are accurate as of that date/time and are subject to change; the price and availability shown on Amazon at the time of purchase will apply to the purchase of this product.

As an eBay Partner, we may be compensated if you make a purchase.

The Two Speakers In Full

Dynaudio Emit 20: $1,049.00 Amazon eBay

Dynaudio Emit 20 ranking card

Pros: Two-way design with a 28mm Esotar soft dome tweeter (Hexis-damped) and an 18cm mid-woofer, using a first-order crossover on the tweeter and second-order on the woofer. Exceptional bass extension for a bookshelf speaker - reaches a clean, authoritative 40Hz in-room, rare enough that the reviewer says most listeners could skip a subwoofer for typical music. Very low distortion across the board, staying below 1% THD down to 40Hz at 86dB and below 3% even at 96dB - unusually clean bass performance where most two-way bookshelf speakers start rising in distortion around 80Hz. Wide, remarkably consistent horizontal directivity (about ±50-60°) that holds steady up to roughly 13kHz - rare for a speaker in this format, thanks to a beveled tweeter edge that acts as a mild waveguide. Excellent compression and dynamic-range linearity at the frequency extremes, actually showing slight bass enhancement rather than the sharp low-end compression common in similarly-sized bookshelf speakers.

Cons: A resonance around 600-800Hz gives snares and similar percussion a muffled, flat quality lacking impact - confirmed as originating in the woofer itself (isolated via measurements of the raw driver out of the cabinet), and attempts at constrained-layer damping didn’t resolve it. A peak around 4kHz adds a sharp, edgy quality to some male vocals. A roughly 5dB boost above 10kHz gives cymbals and hi-hats excess shimmer that can sound unnatural, especially pointed directly on-axis. Vertical dispersion shows two separate crossover-related notches (above and below the tweeter reference line around 5kHz) rather than the usual single one, a direct consequence of the shallow crossover slopes used on both drivers. Multitone distortion is elevated in the midrange, possibly due to the woofer’s magnet structure lacking a shorting ring. Best aimed slightly off-axis (about 10-15° of toe-out) to tame the excess high-frequency shimmer, rather than pointed straight at the listener.

Bass Extension (-10dB)33Hz (measured, Erin's Audio Corner)
Bass Extension (-3dB)54Hz (measured, Erin's Audio Corner)
Dimensions14.6"H x 8.1"W x 12.3"D (370.0 x 205.0 x 312.0 mm)
Drivers7.1" Magnesium Silicate Polymer woofer, 1.1" Cerotar soft dome with Hexis tweeter
Impedance6 ohms nominal (5.5 ohms minimum above 80Hz, measured, Erin's Audio Corner)
Sensitivity83.5dB (measured, Erin's Audio Corner; 86dB manufacturer specified)
Weight12.8 lbs / 5.8 kg
Woofer Cabinetported, rear

Wharfedale Diamond 9.1: Discontinued eBay

Wharfedale Diamond 9.1 ranking card

Pros: The first design was a pretty good sounding speaker, the speaker was then outsourced to China and lost 1.5kg and was made with cheap parts and sounds much worse. Slightly rolled off in the treble by about 3dB

Cons: All current new ones sold today are the crap version. Discontinued.

Dimensions11.7"H x 7.6"W x 10.9"D (296.0 x 194.0 x 278.0 mm)
DiscontinuedYes
Drivers6.5" Kevlar cone woofer, 1" soft dome tweeter
Impedance6 ohms
Sensitivity87dB
Weight12.1 lbs / 5.5 kg (good version), 9.9 lbs / 4.5 kg (bad version) each
Woofer Cabinetported